[U-Boot] Micrel Controller KSZ8841-16MBL

[Douglas Lopes Pereira]

Hi all,

I need some help here...

I'm working on adding a driver for KSZ8841 ethernet controller which I found
at this forum: blackfin.uclinux.org.

I was looking at the mail list archive and found a message from Prafulla
answering Raphael Amorin.

Mr. Prafulla suggested him to add the input code into drivers/net/phy/ and
public interfaces in netdev.h

Since drivers/net/phy/ does not exist anymore, I'm assuming that input code
should go to drivers/net/ instead.

But what about the public interfaces (aka. eth_init, eth_send)? Where should
it go?

Thanks for your time,
Best regards,
Douglas

[tags: KSZ8841; KSZ8842; KSZ884X; KS8841; KS8842; KS884X; Micrel; Ethernet
Controller]