[U-Boot] [PATCH v3 00/19] SPEAr : Network support for spear platforms and SPEAr1300
Vipin KUMAR
vipin.kumar at st.com
Fri Jun 11 08:14:16 CEST 2010
Dear Tom, Wolfgang,
Can you please let me know the status of the remainging patches of this patch-set.
I have not received any reply after sending v3 patch a long time back
These are the Acks I have already received
SPEAr : Configuring FSMC driver for NAND interface
http://www.mail-archive.com/u-boot@lists.denx.de/msg31656.html
SPEAr : FSMC driver support added
http://www.mail-archive.com/u-boot@lists.denx.de/msg31655.html
SPEAr : i2c driver moved completely into drivers/i2c
http://www.mail-archive.com/u-boot@lists.denx.de/msg31604.html
SPEAr : USB Device Controller driver support added
http://www.mail-archive.com/u-boot@lists.denx.de/msg32362.html
SPEAr : macb driver support added for spear310 and spear320
http://www.mail-archive.com/u-boot@lists.denx.de/msg33153.html
SPEAr : Network support configured for spear SoCs
http://www.mail-archive.com/u-boot@lists.denx.de/msg33152.html
Thanks in advance
Regards
Vipin
On 5/28/2010 10:22 PM, Vipin Kumar wrote:
> Dear Wolfgang,
>
> This patch-set as been pending for a long time and it seems Tom is also away
> from mails. A few patches have already been Acked by respective device owners
>
> Please let me know how do I get this patch-set included in 2006.06 release
>
> Thanks in advance
> Vipin
>
> On Fri, May 14, 2010 at 8:26 AM, Vipin KUMAR <vipin.kumar at st.com> wrote:
>> Dear Tom,
>>
>> I am still waiting for Ack/feedback if any on this patchset v3
>> All feedbacks provided by you on patchset v2 have been incorporated
>>
>> Regards
>> Vipin
>>
>> On 5/9/2010 7:46 PM, Vipin Kumar wrote:
>>> Hello Tom,
>>>
>>> Please consider this patch-set for mainline submission.
>>> Please let me know if there are any changes to be made
>>> in code or if the patches are good to go into mainline
>>>
>>> Thanks & Regards
>>> Vipin
>>>
>>> On Thu, May 6, 2010 at 4:48 PM, Vipin KUMAR <vipin.kumar at st.com> wrote:
>>>> Hello Tom,
>>>> The following patch-set contains all the accepted feedbacks on patch-set v2.
>>>> Please consider this for submission into mainline
>>>>
>>>> Below changes are introduced other than the recieved review comments
>>>> 1. Introduced a CONFIG_DW_SEARCH_PHY definition, which if defined searches
>>>> the ethernet phy address. Searching was always enabled in earlier patch
>>>> 2. Introduced a new function dw_write_hwaddr in ethernet driver and
>>>> registered it as a callback via dev->write_hwaddr. This is a new feature
>>>> recently implemented by Ben.
>>>>
>>>> Thanks in advance
>>>>
>>>> Regards
>>>> Vipin
>>>>
>>>> Vipin Kumar (19):
>>>> u-boot.img file not created when srctree and objtree are different
>>>> change_bit routine defined
>>>> SPEAr : SMI erase and write timeouts increased
>>>> SPEAr : Placing ethaddr write and read within CONFIG_CMD_NET
>>>> SPEAr : Reducing the max RAM size to 128MB
>>>> SPEAr : Basic arch related support added for SPEAr SoCs
>>>> SPEAr : Network driver support added
>>>> SPEAr : Network support configured for spear SoCs
>>>> SPEAr : macb driver support added for spear310 and spear320
>>>> SPEAr : FSMC driver support added
>>>> SPEAr : Configuring FSMC driver for NAND interface
>>>> SPEAr : i2c driver moved completely into drivers/i2c
>>>> SPEAr : smi driver moved completely into drivers/mtd
>>>> SPEAr : USB Device Controller driver support added
>>>> SPEAr : Supporting various configurations for spear3xx and spear6xx
>>>> boards
>>>> SPEAr : Basic spear1300 architecture support added
>>>> SPEAr : spear1300 SoC support added
>>>> SPEAr : Removing extraneous code
>>>> SPEAr : USB device controller bugfixes
>>>>
>>>> MAINTAINERS | 1 +
>>>> MAKEALL | 1 +
>>>> Makefile | 30 +-
>>>> arch/arm/cpu/arm926ejs/spear/Makefile | 3 +-
>>>> arch/arm/cpu/arm926ejs/spear/cpu.c | 78 +++
>>>> arch/arm/cpu/arm_cortexa8/spear13xx/Makefile | 52 ++
>>>> arch/arm/cpu/arm_cortexa8/spear13xx/cache.S | 114 +++++
>>>> arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c | 96 ++++
>>>> .../arm_cortexa8/spear13xx/reset.c} | 52 +--
>>>> arch/arm/cpu/arm_cortexa8/spear13xx/timer.c | 138 +++++
>>>> .../arm/include/asm/arch-spear/clk.h | 26 +-
>>>> arch/arm/include/asm/arch-spear/hardware.h | 16 +-
>>>> arch/arm/include/asm/arch-spear/spr_misc.h | 5 +
>>>> .../arm/include/asm/arch-spear13xx/hardware.h | 33 +-
>>>> arch/arm/include/asm/arch-spear13xx/spr_gpt.h | 85 ++++
>>>> arch/arm/include/asm/arch-spear13xx/spr_misc.h | 317 ++++++++++++
>>>> .../arm/include/asm/arch-spear13xx/sys_proto.h | 29 +-
>>>> arch/arm/include/asm/bitops.h | 11 +-
>>>> board/spear/common/Makefile | 10 +-
>>>> board/spear/common/spr_misc.c | 28 +-
>>>> board/spear/spear1300/Makefile | 51 ++
>>>> board/spear/spear1300/config.mk | 28 +
>>>> board/spear/spear1300/spear1300.c | 88 ++++
>>>> .../spear/spear1300/spr_lowlevel_init.S | 35 +-
>>>> board/spear/spear300/config.mk | 11 -
>>>> board/spear/spear300/spear300.c | 15 +-
>>>> board/spear/spear310/config.mk | 11 -
>>>> board/spear/spear310/spear310.c | 36 ++-
>>>> board/spear/spear320/config.mk | 11 -
>>>> board/spear/spear320/spear320.c | 23 +-
>>>> board/spear/spear600/config.mk | 11 -
>>>> board/spear/spear600/spear600.c | 15 +-
>>>> doc/README.designware_eth | 25 +
>>>> doc/README.spear | 46 ++-
>>>> drivers/i2c/Makefile | 2 +-
>>>> drivers/i2c/{spr_i2c.c => designware_i2c.c} | 4 +-
>>>> .../spr_i2c.h => drivers/i2c/designware_i2c.h | 6 +-
>>>> drivers/mtd/Makefile | 2 +-
>>>> drivers/mtd/nand/Makefile | 2 +-
>>>> drivers/mtd/nand/fsmc_nand.c | 366 ++++++++++++++
>>>> drivers/mtd/nand/spr_nand.c | 124 -----
>>>> drivers/mtd/{spr_smi.c => st_smi.c} | 59 ++-
>>>> .../arch-spear/spr_smi.h => drivers/mtd/st_smi.h | 8 +-
>>>> drivers/net/Makefile | 1 +
>>>> drivers/net/designware.c | 531 ++++++++++++++++++++
>>>> drivers/net/designware.h | 264 ++++++++++
>>>> drivers/serial/usbtty.h | 4 +-
>>>> drivers/usb/gadget/Makefile | 2 +-
>>>> drivers/usb/gadget/{spr_udc.c => designware_udc.c} | 116 +++--
>>>> include/configs/spear-common.h | 33 +-
>>>> include/configs/spear13xx_evb.h | 202 ++++++++
>>>> include/configs/{spear3xx.h => spear3xx_evb.h} | 30 ++
>>>> include/configs/{spear6xx.h => spear6xx_evb.h} | 13 +
>>>> include/linux/mtd/fsmc_nand.h | 104 ++++
>>>> include/netdev.h | 1 +
>>>> include/usb/{spr_udc.h => designware_udc.h} | 6 +-
>>>> 56 files changed, 2993 insertions(+), 418 deletions(-)
>>>> create mode 100644 arch/arm/cpu/arm926ejs/spear/cpu.c
>>>> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/Makefile
>>>> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cache.S
>>>> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c
>>>> rename arch/arm/{include/asm/arch-spear/spr_nand.h => cpu/arm_cortexa8/spear13xx/reset.c} (50%)
>>>> mode change 100644 => 100755
>>>> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/timer.c
>>>> copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear/clk.h (64%)
>>>> copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear13xx/hardware.h (58%)
>>>> create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_gpt.h
>>>> create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_misc.h
>>>> copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear13xx/sys_proto.h (64%)
>>>> create mode 100644 board/spear/spear1300/Makefile
>>>> create mode 100644 board/spear/spear1300/config.mk
>>>> create mode 100644 board/spear/spear1300/spear1300.c
>>>> copy include/configs/spear6xx.h => board/spear/spear1300/spr_lowlevel_init.S (56%)
>>>> create mode 100644 doc/README.designware_eth
>>>> rename drivers/i2c/{spr_i2c.c => designware_i2c.c} (98%)
>>>> rename arch/arm/include/asm/arch-spear/spr_i2c.h => drivers/i2c/designware_i2c.h (98%)
>>>> create mode 100644 drivers/mtd/nand/fsmc_nand.c
>>>> delete mode 100644 drivers/mtd/nand/spr_nand.c
>>>> rename drivers/mtd/{spr_smi.c => st_smi.c} (94%)
>>>> rename arch/arm/include/asm/arch-spear/spr_smi.h => drivers/mtd/st_smi.h (96%)
>>>> create mode 100644 drivers/net/designware.c
>>>> create mode 100644 drivers/net/designware.h
>>>> rename drivers/usb/gadget/{spr_udc.c => designware_udc.c} (91%)
>>>> create mode 100644 include/configs/spear13xx_evb.h
>>>> rename include/configs/{spear3xx.h => spear3xx_evb.h} (85%)
>>>> rename include/configs/{spear6xx.h => spear6xx_evb.h} (82%)
>>>> create mode 100644 include/linux/mtd/fsmc_nand.h
>>>> rename include/usb/{spr_udc.h => designware_udc.h} (98%)
>>>>
>>>> _______________________________________________
>>>> U-Boot mailing list
>>>> U-Boot at lists.denx.de
>>>> http://lists.denx.de/mailman/listinfo/u-boot
>>>>
>>>
>>
>>
>
More information about the U-Boot
mailing list