[U-Boot] [PATCH v3 00/19] SPEAr : Network support for spear platforms and SPEAr1300
Vipin KUMAR
vipin.kumar at st.com
Mon Jun 14 10:12:57 CEST 2010
On 6/11/2010 11:44 AM, vipink wrote:
> Dear Tom, Wolfgang,
>
> Can you please let me know the status of the remainging patches of this patch-set.
> I have not received any reply after sending v3 patch a long time back
>
Dear Tom, Wolfgang
A gentle reminder
Regards
Vipin
> These are the Acks I have already received
>
> SPEAr : Configuring FSMC driver for NAND interface
> http://www.mail-archive.com/u-boot@lists.denx.de/msg31656.html
> SPEAr : FSMC driver support added
> http://www.mail-archive.com/u-boot@lists.denx.de/msg31655.html
> SPEAr : i2c driver moved completely into drivers/i2c
> http://www.mail-archive.com/u-boot@lists.denx.de/msg31604.html
> SPEAr : USB Device Controller driver support added
> http://www.mail-archive.com/u-boot@lists.denx.de/msg32362.html
> SPEAr : macb driver support added for spear310 and spear320
> http://www.mail-archive.com/u-boot@lists.denx.de/msg33153.html
> SPEAr : Network support configured for spear SoCs
> http://www.mail-archive.com/u-boot@lists.denx.de/msg33152.html
>
> Thanks in advance
>
> Regards
> Vipin
>
> On 5/28/2010 10:22 PM, Vipin Kumar wrote:
>> Dear Wolfgang,
>>
>> This patch-set as been pending for a long time and it seems Tom is also away
>> from mails. A few patches have already been Acked by respective device owners
>>
>> Please let me know how do I get this patch-set included in 2006.06 release
>>
>> Thanks in advance
>> Vipin
>>
>> On Fri, May 14, 2010 at 8:26 AM, Vipin KUMAR <vipin.kumar at st.com> wrote:
>>> Dear Tom,
>>>
>>> I am still waiting for Ack/feedback if any on this patchset v3
>>> All feedbacks provided by you on patchset v2 have been incorporated
>>>
>>> Regards
>>> Vipin
>>>
>>> On 5/9/2010 7:46 PM, Vipin Kumar wrote:
>>>> Hello Tom,
>>>>
>>>> Please consider this patch-set for mainline submission.
>>>> Please let me know if there are any changes to be made
>>>> in code or if the patches are good to go into mainline
>>>>
>>>> Thanks & Regards
>>>> Vipin
>>>>
>>>> On Thu, May 6, 2010 at 4:48 PM, Vipin KUMAR <vipin.kumar at st.com> wrote:
>>>>> Hello Tom,
>>>>> The following patch-set contains all the accepted feedbacks on patch-set v2.
>>>>> Please consider this for submission into mainline
>>>>>
>>>>> Below changes are introduced other than the recieved review comments
>>>>> 1. Introduced a CONFIG_DW_SEARCH_PHY definition, which if defined searches
>>>>> the ethernet phy address. Searching was always enabled in earlier patch
>>>>> 2. Introduced a new function dw_write_hwaddr in ethernet driver and
>>>>> registered it as a callback via dev->write_hwaddr. This is a new feature
>>>>> recently implemented by Ben.
>>>>>
>>>>> Thanks in advance
>>>>>
>>>>> Regards
>>>>> Vipin
>>>>>
>>>>> Vipin Kumar (19):
>>>>> u-boot.img file not created when srctree and objtree are different
>>>>> change_bit routine defined
>>>>> SPEAr : SMI erase and write timeouts increased
>>>>> SPEAr : Placing ethaddr write and read within CONFIG_CMD_NET
>>>>> SPEAr : Reducing the max RAM size to 128MB
>>>>> SPEAr : Basic arch related support added for SPEAr SoCs
>>>>> SPEAr : Network driver support added
>>>>> SPEAr : Network support configured for spear SoCs
>>>>> SPEAr : macb driver support added for spear310 and spear320
>>>>> SPEAr : FSMC driver support added
>>>>> SPEAr : Configuring FSMC driver for NAND interface
>>>>> SPEAr : i2c driver moved completely into drivers/i2c
>>>>> SPEAr : smi driver moved completely into drivers/mtd
>>>>> SPEAr : USB Device Controller driver support added
>>>>> SPEAr : Supporting various configurations for spear3xx and spear6xx
>>>>> boards
>>>>> SPEAr : Basic spear1300 architecture support added
>>>>> SPEAr : spear1300 SoC support added
>>>>> SPEAr : Removing extraneous code
>>>>> SPEAr : USB device controller bugfixes
>>>>>
>>>>> MAINTAINERS | 1 +
>>>>> MAKEALL | 1 +
>>>>> Makefile | 30 +-
>>>>> arch/arm/cpu/arm926ejs/spear/Makefile | 3 +-
>>>>> arch/arm/cpu/arm926ejs/spear/cpu.c | 78 +++
>>>>> arch/arm/cpu/arm_cortexa8/spear13xx/Makefile | 52 ++
>>>>> arch/arm/cpu/arm_cortexa8/spear13xx/cache.S | 114 +++++
>>>>> arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c | 96 ++++
>>>>> .../arm_cortexa8/spear13xx/reset.c} | 52 +--
>>>>> arch/arm/cpu/arm_cortexa8/spear13xx/timer.c | 138 +++++
>>>>> .../arm/include/asm/arch-spear/clk.h | 26 +-
>>>>> arch/arm/include/asm/arch-spear/hardware.h | 16 +-
>>>>> arch/arm/include/asm/arch-spear/spr_misc.h | 5 +
>>>>> .../arm/include/asm/arch-spear13xx/hardware.h | 33 +-
>>>>> arch/arm/include/asm/arch-spear13xx/spr_gpt.h | 85 ++++
>>>>> arch/arm/include/asm/arch-spear13xx/spr_misc.h | 317 ++++++++++++
>>>>> .../arm/include/asm/arch-spear13xx/sys_proto.h | 29 +-
>>>>> arch/arm/include/asm/bitops.h | 11 +-
>>>>> board/spear/common/Makefile | 10 +-
>>>>> board/spear/common/spr_misc.c | 28 +-
>>>>> board/spear/spear1300/Makefile | 51 ++
>>>>> board/spear/spear1300/config.mk | 28 +
>>>>> board/spear/spear1300/spear1300.c | 88 ++++
>>>>> .../spear/spear1300/spr_lowlevel_init.S | 35 +-
>>>>> board/spear/spear300/config.mk | 11 -
>>>>> board/spear/spear300/spear300.c | 15 +-
>>>>> board/spear/spear310/config.mk | 11 -
>>>>> board/spear/spear310/spear310.c | 36 ++-
>>>>> board/spear/spear320/config.mk | 11 -
>>>>> board/spear/spear320/spear320.c | 23 +-
>>>>> board/spear/spear600/config.mk | 11 -
>>>>> board/spear/spear600/spear600.c | 15 +-
>>>>> doc/README.designware_eth | 25 +
>>>>> doc/README.spear | 46 ++-
>>>>> drivers/i2c/Makefile | 2 +-
>>>>> drivers/i2c/{spr_i2c.c => designware_i2c.c} | 4 +-
>>>>> .../spr_i2c.h => drivers/i2c/designware_i2c.h | 6 +-
>>>>> drivers/mtd/Makefile | 2 +-
>>>>> drivers/mtd/nand/Makefile | 2 +-
>>>>> drivers/mtd/nand/fsmc_nand.c | 366 ++++++++++++++
>>>>> drivers/mtd/nand/spr_nand.c | 124 -----
>>>>> drivers/mtd/{spr_smi.c => st_smi.c} | 59 ++-
>>>>> .../arch-spear/spr_smi.h => drivers/mtd/st_smi.h | 8 +-
>>>>> drivers/net/Makefile | 1 +
>>>>> drivers/net/designware.c | 531 ++++++++++++++++++++
>>>>> drivers/net/designware.h | 264 ++++++++++
>>>>> drivers/serial/usbtty.h | 4 +-
>>>>> drivers/usb/gadget/Makefile | 2 +-
>>>>> drivers/usb/gadget/{spr_udc.c => designware_udc.c} | 116 +++--
>>>>> include/configs/spear-common.h | 33 +-
>>>>> include/configs/spear13xx_evb.h | 202 ++++++++
>>>>> include/configs/{spear3xx.h => spear3xx_evb.h} | 30 ++
>>>>> include/configs/{spear6xx.h => spear6xx_evb.h} | 13 +
>>>>> include/linux/mtd/fsmc_nand.h | 104 ++++
>>>>> include/netdev.h | 1 +
>>>>> include/usb/{spr_udc.h => designware_udc.h} | 6 +-
>>>>> 56 files changed, 2993 insertions(+), 418 deletions(-)
>>>>> create mode 100644 arch/arm/cpu/arm926ejs/spear/cpu.c
>>>>> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/Makefile
>>>>> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cache.S
>>>>> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c
>>>>> rename arch/arm/{include/asm/arch-spear/spr_nand.h => cpu/arm_cortexa8/spear13xx/reset.c} (50%)
>>>>> mode change 100644 => 100755
>>>>> create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/timer.c
>>>>> copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear/clk.h (64%)
>>>>> copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear13xx/hardware.h (58%)
>>>>> create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_gpt.h
>>>>> create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_misc.h
>>>>> copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear13xx/sys_proto.h (64%)
>>>>> create mode 100644 board/spear/spear1300/Makefile
>>>>> create mode 100644 board/spear/spear1300/config.mk
>>>>> create mode 100644 board/spear/spear1300/spear1300.c
>>>>> copy include/configs/spear6xx.h => board/spear/spear1300/spr_lowlevel_init.S (56%)
>>>>> create mode 100644 doc/README.designware_eth
>>>>> rename drivers/i2c/{spr_i2c.c => designware_i2c.c} (98%)
>>>>> rename arch/arm/include/asm/arch-spear/spr_i2c.h => drivers/i2c/designware_i2c.h (98%)
>>>>> create mode 100644 drivers/mtd/nand/fsmc_nand.c
>>>>> delete mode 100644 drivers/mtd/nand/spr_nand.c
>>>>> rename drivers/mtd/{spr_smi.c => st_smi.c} (94%)
>>>>> rename arch/arm/include/asm/arch-spear/spr_smi.h => drivers/mtd/st_smi.h (96%)
>>>>> create mode 100644 drivers/net/designware.c
>>>>> create mode 100644 drivers/net/designware.h
>>>>> rename drivers/usb/gadget/{spr_udc.c => designware_udc.c} (91%)
>>>>> create mode 100644 include/configs/spear13xx_evb.h
>>>>> rename include/configs/{spear3xx.h => spear3xx_evb.h} (85%)
>>>>> rename include/configs/{spear6xx.h => spear6xx_evb.h} (82%)
>>>>> create mode 100644 include/linux/mtd/fsmc_nand.h
>>>>> rename include/usb/{spr_udc.h => designware_udc.h} (98%)
>>>>>
>>>>> _______________________________________________
>>>>> U-Boot mailing list
>>>>> U-Boot at lists.denx.de
>>>>> http://lists.denx.de/mailman/listinfo/u-boot
>>>>>
>>>>
>>>
>>>
>>
>
More information about the U-Boot
mailing list