[U-Boot] [PATCH] DaVinci: EMAC: Get EMAC_MDIO_PHY_NUM from config files

[Paulraj, Sandeep]

> 
> Currently EMAC_MDIO_PHY_NUM is defined as 1 in emac_defs.h.
> Because of this, EMAC does not work on EVMs which do not have phy
> connected at 1. Moving the macro to board config file makes this
> configurable depending on where the phy is connected on the MDIO bus.
> 
> This patch fixes the board reset issue observed during network access
> on DM365EVM. EMAC driver was assuming EMAC_MDIO_PHY_NUM as 1
> but it is 0 on DM365EVM.
> 
> This patch is verified on da830/omap-l137, dm365 and dm644x evms.
> 
> Signed-off-by: Prakash PM <prakash.pm at ti.com>
> ---

Thanks

Will apply to u-boot-ti

Sandeep