[U-Boot] [PATCH] DaVinci: EMAC: Get EMAC_MDIO_PHY_NUM from config files

[Paulraj, Sandeep]

> >
> > Currently EMAC_MDIO_PHY_NUM is defined as 1 in emac_defs.h.
> > Because of this, EMAC does not work on EVMs which do not have phy
> > connected at 1. Moving the macro to board config file makes this
> > configurable depending on where the phy is connected on the MDIO bus.
> >
> > This patch fixes the board reset issue observed during network access
> > on DM365EVM. EMAC driver was assuming EMAC_MDIO_PHY_NUM as 1
> > but it is 0 on DM365EVM.
> >
> > This patch is verified on da830/omap-l137, dm365 and dm644x evms.
> >
> > Signed-off-by: Prakash PM <prakash.pm at ti.com>
> > ---
> 
When I ran MAKEALL, Davinci SONATA gave a warning.
Please take care of that. It is an EVM based on the 6446.

Sandeep