[U-Boot] [PATCH 2/2] MPC8308ERDB: minimal support for devboard from Freescale

[Aggrwal Poonam-B10812]

> -----Original Message-----
> From: u-boot-bounces at lists.denx.de
[mailto:u-boot-bounces at lists.denx.de]
> On Behalf Of Ilya Yanok
> Sent: Friday, June 25, 2010 1:07 AM
> To: Phillips Kim-R1AAHA
> Cc: u-boot at lists.denx.de
> Subject: Re: [U-Boot] [PATCH 2/2] MPC8308ERDB: minimal support for
> devboard from Freescale
> 
> Hi Kim,
> 
> On 24.06.2010 22:00, Kim Phillips wrote:
> >> I've enabled icache and now the board sometimes resets twice after
> >> U-Boot 'reset' command:
> >>
> >
> >> (It doesn't always stop at "DRAM:" line but that position is most
> >> frequent) Maybe you have some ideas on this subject?
> >>
> > hmm, if it's only on soft-resets, can you try adding
> > HID0_ENABLE_INSTRUCTION_CACHE to CONFIG_SYS_HID0_INIT in addition to
> > _FINAL?  Some cache state is preserved over a soft-reset...
> >
> 
> Thanks for your advice but this doesn't help...
>
Just from my experience on few other boards, this could be a DDR
configuration issue.
Can you try to run at lower frequencies?..Or may be playing with DDR
controller timings.

Regards
Poonam
 
> Regards, Ilya.
> 
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> http://lists.denx.de/mailman/listinfo/u-boot