[U-Boot] [PATCH] arm: kirkwood: suen3: fixed build warning

[Prafulla Wadaskar]

This patch fixes following build warning

Invalid Kwbimage command Type - valid names are: BOOT_FROM, NAND_ECC_MODE, NAND_PAGE_SIZE, SATA_PIO_MODE, DDR_INIT_DELAY, DATA, , spi, nand, sata, pex, uart

Signed-off-by: Prafulla Wadaskar <prafulla at marvell.com>
---
 board/keymile/km_arm/kwbimage.cfg |    3 +--
 1 files changed, 1 insertions(+), 2 deletions(-)

diff --git a/board/keymile/km_arm/kwbimage.cfg b/board/keymile/km_arm/kwbimage.cfg
index d6edd27..26d6aa0 100644
--- a/board/keymile/km_arm/kwbimage.cfg
+++ b/board/keymile/km_arm/kwbimage.cfg
@@ -64,7 +64,6 @@ DATA 0xFFD01400 0x43000400	# SDRAM Configuration Register
 # bit31-30: 01
 
 DATA 0xFFD01404 0x36343000	# DDR Controller Control Low
-		0x38543000
 # bit 3-0:  0 reserved
 # bit 4:    0=addr/cmd in smame cycle
 # bit 5:    0=clk is driven during self refresh, we don't care for APX
@@ -170,7 +169,7 @@ DATA 0xFFD0149C 0x0000E90F	# CPU ODT Control
 # bit11-10:2, DQ_ODTSel. ODT select turned on, 75 ohm
 
 DATA 0xFFD01480 0x00000001	# DDR Initialization Control
-#bit0=1, enable DDR init upon this register write
+# bit0=1, enable DDR init upon this register write
 
 # End of Header extension
 DATA 0x0 0x0
-- 
1.5.3.3