[U-Boot] [PATCH] arm: kirkwood: suen3: fixed build warning

[Tom]

Prafulla Wadaskar wrote:
> This patch fixes following build warning
> 
> Invalid Kwbimage command Type - valid names are: BOOT_FROM, NAND_ECC_MODE, NAND_PAGE_SIZE, SATA_PIO_MODE, DDR_INIT_DELAY, DATA, , spi, nand, sata, pex, uart
> 
> Signed-off-by: Prafulla Wadaskar <prafulla at marvell.com>
> ---
>  board/keymile/km_arm/kwbimage.cfg |    3 +--
>  1 files changed, 1 insertions(+), 2 deletions(-)
> 
> diff --git a/board/keymile/km_arm/kwbimage.cfg b/board/keymile/km_arm/kwbimage.cfg
> index d6edd27..26d6aa0 100644
> --- a/board/keymile/km_arm/kwbimage.cfg
> +++ b/board/keymile/km_arm/kwbimage.cfg
> @@ -64,7 +64,6 @@ DATA 0xFFD01400 0x43000400	# SDRAM Configuration Register
>  # bit31-30: 01
>  
>  DATA 0xFFD01404 0x36343000	# DDR Controller Control Low
> -		0x38543000
>  # bit 3-0:  0 reserved
>  # bit 4:    0=addr/cmd in smame cycle
>  # bit 5:    0=clk is driven during self refresh, we don't care for APX
> @@ -170,7 +169,7 @@ DATA 0xFFD0149C 0x0000E90F	# CPU ODT Control
>  # bit11-10:2, DQ_ODTSel. ODT select turned on, 75 ohm
>  
>  DATA 0xFFD01480 0x00000001	# DDR Initialization Control
> -#bit0=1, enable DDR init upon this register write
> +# bit0=1, enable DDR init upon this register write
>  
>  # End of Header extension
>  DATA 0x0 0x0
This patch did not fix any of the warnings I saw.
Please recheck.
Tom