[U-Boot] [PATCH] arm: kirkwood: suen3: fixed build warning

Prafulla Wadaskar prafulla at marvell.com
Fri Mar 5 06:14:55 CET 2010


 

> -----Original Message-----
> From: Tom [mailto:Tom.Rix at windriver.com] 
> Sent: Thursday, March 04, 2010 7:25 PM
> To: Prafulla Wadaskar
> Cc: u-boot at lists.denx.de; Ashish Karkare; Prabhanjan Sarnaik
> Subject: Re: [U-Boot] [PATCH] arm: kirkwood: suen3: fixed 
> build warning
> 
> Prafulla Wadaskar wrote:
> > This patch fixes following build warning
> > 
> > Invalid Kwbimage command Type - valid names are: BOOT_FROM, 
> NAND_ECC_MODE, NAND_PAGE_SIZE, SATA_PIO_MODE, DDR_INIT_DELAY, 
> DATA, , spi, nand, sata, pex, uart
> > 
> > Signed-off-by: Prafulla Wadaskar <prafulla at marvell.com>
> > ---
> >  board/keymile/km_arm/kwbimage.cfg |    3 +--
> >  1 files changed, 1 insertions(+), 2 deletions(-)
> > 
> > diff --git a/board/keymile/km_arm/kwbimage.cfg 
> b/board/keymile/km_arm/kwbimage.cfg
> > index d6edd27..26d6aa0 100644
> > --- a/board/keymile/km_arm/kwbimage.cfg
> > +++ b/board/keymile/km_arm/kwbimage.cfg
> > @@ -64,7 +64,6 @@ DATA 0xFFD01400 0x43000400	# SDRAM 
> Configuration Register
> >  # bit31-30: 01
> >  
> >  DATA 0xFFD01404 0x36343000	# DDR Controller Control Low
> > -		0x38543000
> >  # bit 3-0:  0 reserved
> >  # bit 4:    0=addr/cmd in smame cycle
> >  # bit 5:    0=clk is driven during self refresh, we don't 
> care for APX
> > @@ -170,7 +169,7 @@ DATA 0xFFD0149C 0x0000E90F	# CPU 
> ODT Control
> >  # bit11-10:2, DQ_ODTSel. ODT select turned on, 75 ohm
> >  
> >  DATA 0xFFD01480 0x00000001	# DDR Initialization Control
> > -#bit0=1, enable DDR init upon this register write
> > +# bit0=1, enable DDR init upon this register write
> >  
> >  # End of Header extension
> >  DATA 0x0 0x0
> This patch did not fix any of the warnings I saw.
> Please recheck.

Hi Tom
I am sorry to say,
it is not build warning but it is runtime stderr generated during kwbimage.cfg parsing.
This patch removes above mentioned "Invalid Kwbimage command Type" error reported by mkimage tool during u-boot.kwb target creation for this board.

Regards..
Prafulla . .

> Tom
> 
> 


More information about the U-Boot mailing list