[U-Boot] [PATCH] arm: kirkwood: suen3: fixed build warning

[Tom]

Prafulla Wadaskar wrote:
>  
> 
>> -----Original Message-----
>> From: Tom [mailto:Tom.Rix at windriver.com] 
>> Sent: Thursday, March 04, 2010 7:25 PM
>> To: Prafulla Wadaskar
>> Cc: u-boot at lists.denx.de; Ashish Karkare; Prabhanjan Sarnaik
>> Subject: Re: [U-Boot] [PATCH] arm: kirkwood: suen3: fixed 
>> build warning
>>
>> Prafulla Wadaskar wrote:
>>> This patch fixes following build warning
>>>
>>> Invalid Kwbimage command Type - valid names are: BOOT_FROM, 
>> NAND_ECC_MODE, NAND_PAGE_SIZE, SATA_PIO_MODE, DDR_INIT_DELAY, 
>> DATA, , spi, nand, sata, pex, uart
>>> Signed-off-by: Prafulla Wadaskar <prafulla at marvell.com>
>>> ---
>>>  board/keymile/km_arm/kwbimage.cfg |    3 +--
>>>  1 files changed, 1 insertions(+), 2 deletions(-)
>>>
>>> diff --git a/board/keymile/km_arm/kwbimage.cfg 
>> b/board/keymile/km_arm/kwbimage.cfg
>>> index d6edd27..26d6aa0 100644
>>> --- a/board/keymile/km_arm/kwbimage.cfg
>>> +++ b/board/keymile/km_arm/kwbimage.cfg
>>> @@ -64,7 +64,6 @@ DATA 0xFFD01400 0x43000400	# SDRAM 
>> Configuration Register
>>>  # bit31-30: 01
>>>  
>>>  DATA 0xFFD01404 0x36343000	# DDR Controller Control Low
>>> -		0x38543000
>>>  # bit 3-0:  0 reserved
>>>  # bit 4:    0=addr/cmd in smame cycle
>>>  # bit 5:    0=clk is driven during self refresh, we don't 
>> care for APX
>>> @@ -170,7 +169,7 @@ DATA 0xFFD0149C 0x0000E90F	# CPU 
>> ODT Control
>>>  # bit11-10:2, DQ_ODTSel. ODT select turned on, 75 ohm
>>>  
>>>  DATA 0xFFD01480 0x00000001	# DDR Initialization Control
>>> -#bit0=1, enable DDR init upon this register write
>>> +# bit0=1, enable DDR init upon this register write
>>>  
>>>  # End of Header extension
>>>  DATA 0x0 0x0
>> This patch did not fix any of the warnings I saw.
>> Please recheck.
> 
> Hi Tom
> I am sorry to say,
> it is not build warning but it is runtime stderr generated during kwbimage.cfg parsing.
> This patch removes above mentioned "Invalid Kwbimage command Type" error reported by mkimage tool during u-boot.kwb target creation for this board.
> 

Ah!
Ok that helps.
I did not hold up your pull request for this.
Would you like this to go into ARM now?

Tom

> Regards..
> Prafulla . .
> 
>> Tom
>>