[U-Boot] [PATCH 02/28] cfi flash: add status polling method for amd flash

Thomas Chou thomas at wytron.com.tw
Fri Mar 19 08:43:27 CET 2010


This patch adds status polling method to offer an alternative to
data toggle method for amd flash chips.

This patch is needed for nios2 cfi flash interface, where the bus
controller performs 4 bytes read cycles for a single byte read
instruction. The data toggle method can not detect chip busy
status correctly. So we have to poll DQ7, which will be inverted
when the chip is busy.

This feature is enabled with the config def,
CONFIG_SYS_CFI_FLASH_STATUS_POLL

Signed-off-by: Thomas Chou <thomas at wytron.com.tw>
---
 drivers/mtd/cfi_flash.c |   94 ++++++++++++++++++++++++++++++++++++++++++++++-
 1 files changed, 92 insertions(+), 2 deletions(-)

diff --git a/drivers/mtd/cfi_flash.c b/drivers/mtd/cfi_flash.c
index fdba297..4baa9dc 100644
--- a/drivers/mtd/cfi_flash.c
+++ b/drivers/mtd/cfi_flash.c
@@ -555,6 +555,50 @@ static int flash_status_check (flash_info_t * info, flash_sect_t sector,
 	return ERR_OK;
 }
 
+#ifdef CONFIG_SYS_CFI_FLASH_STATUS_POLL
+static int flash_status_poll(flash_info_t *info, cfiword_t cword, void *addr,
+			     ulong tout, char *prompt)
+{
+	ulong start;
+	int ready;
+
+#if CONFIG_SYS_HZ != 1000
+	tout *= CONFIG_SYS_HZ/1000;
+#endif
+
+	/* Wait for command completion */
+	start = get_timer(0);
+	while (1) {
+		switch (info->portwidth) {
+		case FLASH_CFI_8BIT:
+			ready = flash_read8(addr) == cword.c;
+			break;
+		case FLASH_CFI_16BIT:
+			ready = flash_read16(addr) == cword.w;
+			break;
+		case FLASH_CFI_32BIT:
+			ready = flash_read32(addr) == cword.l;
+			break;
+		case FLASH_CFI_64BIT:
+			ready = flash_read64(addr) == cword.ll;
+			break;
+		default:
+			ready = 0;
+			break;
+		}
+		if (ready)
+			break;
+		if (get_timer(start) > tout) {
+			printf("Flash %s timeout at address %lx data %lx\n",
+			       prompt, (ulong)addr, (ulong)flash_read8(addr));
+			return ERR_TIMOUT;
+		}
+		udelay(1);		/* also triggers watchdog */
+	}
+	return ERR_OK;
+}
+#endif
+
 /*-----------------------------------------------------------------------
  * Wait for XSR.7 to be set, if it times out print an error, otherwise
  * do a full status check.
@@ -749,6 +793,13 @@ static int flash_write_cfiword (flash_info_t * info, ulong dest,
 	if (!sect_found)
 		sect = find_sector (info, dest);
 
+#ifdef CONFIG_SYS_CFI_FLASH_STATUS_POLL
+	if (info->vendor == CFI_CMDSET_AMD_EXTENDED ||
+	    info->vendor == CFI_CMDSET_AMD_STANDARD)
+		return flash_status_poll(info, cword, dstaddr,
+					 info->write_tout, "write");
+	else
+#endif
 	return flash_full_status_check (info, sect, info->write_tout, "write");
 }
 
@@ -767,6 +818,7 @@ static int flash_write_cfibuffer (flash_info_t * info, ulong dest, uchar * cp,
 	uint offset = 0;
 	unsigned int shift;
 	uchar write_cmd;
+	cfiword_t cword;
 
 	switch (info->portwidth) {
 	case FLASH_CFI_8BIT:
@@ -911,9 +963,35 @@ static int flash_write_cfibuffer (flash_info_t * info, ulong dest, uchar * cp,
 		}
 
 		flash_write_cmd (info, sector, 0, AMD_CMD_WRITE_BUFFER_CONFIRM);
+#ifdef CONFIG_SYS_CFI_FLASH_STATUS_POLL
+		switch (info->portwidth) {
+		case FLASH_CFI_8BIT:
+			cword.c = flash_read8(src - 1);
+			dst -= 1;
+			break;
+		case FLASH_CFI_16BIT:
+			cword.w = flash_read16(src - 2);
+			dst -= 2;
+			break;
+		case FLASH_CFI_32BIT:
+			cword.l = flash_read32(src - 4);
+			dst -= 4;
+			break;
+		case FLASH_CFI_64BIT:
+			cword.ll = flash_read64(src - 8);
+			dst -= 8;
+			break;
+		default:
+			retcode = ERR_INVAL;
+			goto out_unmap;
+		}
+		retcode = flash_status_poll(info, cword, dst,
+				info->buffer_write_tout, "buffer write");
+#else
 		retcode = flash_full_status_check (info, sector,
 						   info->buffer_write_tout,
 						   "buffer write");
+#endif
 		break;
 
 	default:
@@ -935,6 +1013,8 @@ int flash_erase (flash_info_t * info, int s_first, int s_last)
 	int rcode = 0;
 	int prot;
 	flash_sect_t sect;
+	cfiword_t cword = (cfiword_t) 0xffffffffffffffffULL;
+	ulong dest;
 
 	if (info->flash_id != FLASH_MAN_CFI) {
 		puts ("Can't erase unknown flash type - aborted\n");
@@ -998,6 +1078,17 @@ int flash_erase (flash_info_t * info, int s_first, int s_last)
 				break;
 			}
 
+#ifdef CONFIG_SYS_CFI_FLASH_STATUS_POLL
+			dest = (ulong)flash_map(info, sect, 0);
+			flash_unmap(info, sect, 0, (void *)dest);
+			if ((info->vendor == CFI_CMDSET_AMD_EXTENDED ||
+			     info->vendor == CFI_CMDSET_AMD_STANDARD) &&
+			    flash_status_poll(info, cword, (void *)dest,
+					      info->erase_blk_tout, "erase"))
+				rcode = 1;
+			else
+
+#endif
 			if (flash_full_status_check
 			    (info, sect, info->erase_blk_tout, "erase")) {
 				rcode = 1;
@@ -1980,8 +2071,7 @@ unsigned long flash_init (void)
 	}
 
 	/* Monitor protection ON by default */
-#if (CONFIG_SYS_MONITOR_BASE >= CONFIG_SYS_FLASH_BASE) && \
-	(!defined(CONFIG_MONITOR_IS_IN_RAM))
+#if (CONFIG_SYS_MONITOR_BASE >= CONFIG_SYS_FLASH_BASE)
 	flash_protect (FLAG_PROTECT_SET,
 		       CONFIG_SYS_MONITOR_BASE,
 		       CONFIG_SYS_MONITOR_BASE + monitor_flash_len  - 1,
-- 
1.6.6.1



More information about the U-Boot mailing list