[U-Boot] [PATCH Repost] bugfix: Guruplug: Use standard miiphy call to reset PHY chip.
Mahavir Jain
mjain at marvell.com
Wed May 19 10:56:11 CEST 2010
Current PHY Software Reset operation in guruplug does not
poll reset bit in control register to go to 0(auto clearing)
for making sure reset was successful.This patch uses standard
miiphy call miiphy_reset to make sure proper PHY reset operation.
Signed-off-by: Mahavir Jain <mjain at marvell.com>
---
board/Marvell/guruplug/guruplug.c | 9 +--------
1 files changed, 1 insertions(+), 8 deletions(-)
diff --git a/board/Marvell/guruplug/guruplug.c b/board/Marvell/guruplug/guruplug.c
index ba47ca1..c028a53 100644
--- a/board/Marvell/guruplug/guruplug.c
+++ b/board/Marvell/guruplug/guruplug.c
@@ -146,14 +146,7 @@ void mv_phy_88e1121_init(char *name)
miiphy_write(name, devadr, MV88E1121_PGADR_REG, 0);
/* reset the phy */
- if (miiphy_read (name, devadr, PHY_BMCR, ®) != 0) {
- printf("Err..(%s) PHY status read failed\n", __FUNCTION__);
- return;
- }
- if (miiphy_write (name, devadr, PHY_BMCR, reg | 0x8000) != 0) {
- printf("Err..(%s) PHY reset failed\n", __FUNCTION__);
- return;
- }
+ miiphy_reset(name, devadr);
printf("88E1121 Initialized on %s\n", name);
}
--
1.5.4.3
More information about the U-Boot
mailing list