[U-Boot] [PATCH] fsl_pci_init: Make fsl_pci_init_port() PCI/PCIe aware

[Wolfgang Denk]

Dear Kumar,

In message <1288297499-21417-1-git-send-email-ptyser at xes-inc.com> Peter Tyser wrote:
> Previously fsl_pci_init_port() always assumed that a port was a PCIe
> port and would incorrectly print messages for a PCI port such as the
> following on bootup:
>     PCI1:  32 bit, 33 MHz, sync, host, arbiter
>                 Scanning PCI bus 00
>     PCIE1 on bus 00 - 00
> 
> This change corrects the output of fsl_pci_init_port():
>     PCI1:  32 bit, 33 MHz, sync, host, arbiter
>                 Scanning PCI bus 00
>     PCI1 on bus 00 - 00
> 
> Signed-off-by: Peter Tyser <ptyser at xes-inc.com>
> ---
> Tested on a MPC8548 with PCI, and a MPC8640 with PCIe
> 
>  drivers/pci/fsl_pci_init.c |    6 +++++-
>  1 files changed, 5 insertions(+), 1 deletions(-)

I thought this should go through your tree, as it affects all the FSL
boards.  Or are you waiting for me to pull this in?


Also, there is still this other unresolved issue about indentation of
the PCI messages.  Would you agree to clean this up as I suggested?

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
To be sure of hitting the target, shoot first and, whatever you  hit,
call it the target.