[U-Boot] OT Flashing high volume of devices

[Hamilton Vera]

Dear Wolfgang, thanks for your reply.

Actually we are using NAND, since NAND usually comes with some bad
blocks from the provider I am worried about the procedure and best
practices.

Thank you a lot.

Hamilton Vera



On Thu, Nov 18, 2010 at 6:39 PM, Wolfgang Denk <wd at denx.de> wrote:
> Dear Hamilton Vera,
>
> In message <AANLkTim-w-ijiNpPMsmUM++9MwWsxbOntOdPb5HH6D0Z at mail.gmail.com> you wrote:
>> Hi folks this is probably out off topic, we are happily using uboot in
>> our devices but I am wondering about the procedures to flash/deploy
>> uboot (or any bootloader) in a high scale production environment.
>
> What sort of boot device are you using?  NOR flash? NAND flash?
>
> For high volumes, you can get pre-programmed flash chips, so you have
> a running system when the boards come from assembly.
>
>
> Best regards,
>
> Wolfgang Denk
>
> --
> DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
> HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
> Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
> Computers are not intelligent.  They only think they are.
>



-- 
Hamilton Vera
int Administrator (char Network[],char ComputationalSystems[])
http://hvera.wordpress.com