[U-Boot] [PATCH 1/1 V7] Add board support for hawkboard

[Paulraj, Sandeep]

> 
> The patch adds basic board support for TI's OMAP-L138 based
> Hawkboard. This board is pretty similar to the da850 EVM. Support for
> nand and network access is added in this version.
> 
> The following bootup procedure is used.
> 
> At reset, the Rom Boot Loader(RBL), initialises the ddr and the nand
> controllers and copies the second stage bootloader(nand_spl) to
> RAM. The secondary bootloader then copies u-boot from a predefined
> location in the nand flash to the RAM, and passes control to the
> u-boot image.
> 
> Three config options are supported
> * hawkboard_config - Used to create the u-boot.bin. Tftp the
>  u-boot.bin image to the RAM from u-boot, and flash to the nand flash
>  at address 0xe0000.
> 
> * hawkboard_nand_config - Used to generate the secondary
>  bootloader(nand_spl) image. This creates an elf file u-boot-spl
>  under nand_spl/. Create an AIS signed image using this file, and
>  flash it to the nand flash at address 0x20000. The ais file should
>  fit in one block.
> 
> * hawkboard_uart_config - This is same as the first image, but with
>  the TEXT_BASE as expected by the RBL(0xc1080000). Create the AIS
> 
> Signed-off-by: Sughosh Ganu <urwithsughosh at gmail.com>
> Signed-off-by: Ben Gardiner <bengardiner at nanometrics.ca>

Pushed to u-boot-ti/next

http://git.denx.de/?p=u-boot/u-boot-ti.git;a=commitdiff;h=48571ff00526701c88cfcac1294adf20aeeade74

Regards,
Sandeep