[U-Boot] [PATCH] mpc83xx: restrict UTMI PHY configuration to 831x parts

Kim Phillips kim.phillips at freescale.com
Fri Apr 1 23:53:18 CEST 2011


i.e, to those parts that have PHY_CLK_VALID bits in their USB
CONTROL registers:

mpc8308	 WU_INT, PHY_CLK_SEL, USB_EN, WU_INT_EN, ULPI_INT_EN
mpc831x	 PHY_CLK_VALID, WU_INT, CLKIN_SEL, PHY_CLK_SEL, UTMI_PHY_EN,
	 PLL_RESET, REFSEL, OTG_PORT, KEEP_OTG_ON, LSF_EN, USB_EN,
	 ULPI_INT_EN
mpc834x	 USB_EN, ULPI_INT1_EN (MPH only), ULPI_INT0_EN
mpc837x	 USB_EN, ULPI_INT_EN

(mpc832x, mpc8360 don't have a USB_EHCI_FSL compatible controller)

this prevents non-831x parts from never completing cpu_init_f(),
because the (non-existent) PHY_CLK_VALID bit never gets set.

Reported-by: Andre Schwarz <andre.schwarz at matrix-vision.de>
Signed-off-by: Kim Phillips <kim.phillips at freescale.com>
---
 arch/powerpc/cpu/mpc83xx/cpu_init.c |    4 +---
 1 files changed, 1 insertions(+), 3 deletions(-)

diff --git a/arch/powerpc/cpu/mpc83xx/cpu_init.c b/arch/powerpc/cpu/mpc83xx/cpu_init.c
index 7a1cae7..76afba5 100644
--- a/arch/powerpc/cpu/mpc83xx/cpu_init.c
+++ b/arch/powerpc/cpu/mpc83xx/cpu_init.c
@@ -326,8 +326,7 @@ void cpu_init_f (volatile immap_t * im)
 	im->gpio[1].dat = CONFIG_SYS_GPIO2_DAT;
 	im->gpio[1].dir = CONFIG_SYS_GPIO2_DIR;
 #endif
-#ifdef CONFIG_USB_EHCI_FSL
-#ifndef CONFIG_MPC834x
+#if defined(CONFIG_USB_EHCI_FSL) && defined(CONFIG_MPC831x)
 	uint32_t temp;
 	struct usb_ehci *ehci = (struct usb_ehci *)CONFIG_SYS_FSL_USB_ADDR;
 
@@ -340,7 +339,6 @@ void cpu_init_f (volatile immap_t * im)
 		udelay(1000);
 	} while (!(temp & PHY_CLK_VALID));
 #endif
-#endif
 }
 
 int cpu_init_r (void)
-- 
1.7.4




More information about the U-Boot mailing list