[U-Boot] [PATCH 1/1] MX5:MX53: support for freescale MX53LOCO board

[Jason Liu]

Hi, Stefano,

2011/4/16 Stefano Babic <sbabic at denx.de>:
> On 04/14/2011 10:12 AM, Jason Liu wrote:
>> Hi, Stefano,
>
> Hi Jason,
>
>> Please drop the mx53loco board support patch from u-boot-imx master branch
>> and I will resubmit the following patches soon since the merge window will be
>> closed soon.
>
> Ok - I'll do it.
>
>>
>> (1) clean-up patch:factor out the boot reason code to common code for
>> all the mx5
>> (2) fix-up: address Wolfgang's last minute comments and resubmit the patch.
>>
>> Stefano, do you have some comments about what else I should do?
>
> Please merge your other two patches for the LOCO board together - these
> other patches correct only some CONFIG_ in the board configuration file:
>
>        mx53loco: set mmc env to MMC slot1
>        MX5: Enable flat-device-tree support on mx53 loco board
>
> Submit a single patch with already the correct configuration for the
> LOCO board. I will drop all three current patches from u-boot-imx.

I have sent out V4 patch as you tell. Thanks.

Jason

>
> Best regards,
> Stefano
>
> --
> =====================================================================
> DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
> HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
> Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
> =====================================================================
>