[U-Boot] [PATCH] S5PC2XX: GPIO Macro Values Corrected.

[Chander Kashyap]

Dear Minku,
Please ignore this patch. As i have removed
#define GPIO_DRV_FAST  0x0
#define GPIO_DRV_SLOW  0x1

as these are not defined for s5pc2xx.
But being reffered in s5p_gpio.c.
I will add again and send the patch.
Regards,
Chander

On 18 April 2011 09:31, Chander Kashyap <chander.kashyap at linaro.org> wrote:

> Macro values for Pull Up and Driver Strength were wrong.
>
> Signed-off-by: Chander Kashyap <chander.kashyap at linaro.org>
> ---
>  arch/arm/include/asm/arch-s5pc2xx/gpio.h |    8 +++-----
>  1 files changed, 3 insertions(+), 5 deletions(-)
>
> diff --git a/arch/arm/include/asm/arch-s5pc2xx/gpio.h
> b/arch/arm/include/asm/arch-s5pc2xx/gpio.h
> index 05e5b3e..e49edd4 100644
> --- a/arch/arm/include/asm/arch-s5pc2xx/gpio.h
> +++ b/arch/arm/include/asm/arch-s5pc2xx/gpio.h
> @@ -99,14 +99,12 @@ void gpio_set_rate(struct s5p_gpio_bank *bank, int
> gpio, int mode);
>  /* Pull mode */
>  #define GPIO_PULL_NONE 0x0
>  #define GPIO_PULL_DOWN 0x1
> -#define GPIO_PULL_UP   0x2
> +#define GPIO_PULL_UP   0x3
>
>  /* Drive Strength level */
>  #define GPIO_DRV_1X    0x0
> -#define GPIO_DRV_2X    0x1
> -#define GPIO_DRV_3X    0x2
> +#define GPIO_DRV_3X    0x1
> +#define GPIO_DRV_2X    0x2
>  #define GPIO_DRV_4X    0x3
> -#define GPIO_DRV_FAST  0x0
> -#define GPIO_DRV_SLOW  0x1
>
>  #endif
> --
> 1.7.1
>
>