[U-Boot] [PATCH V5 2/2] MX53: support for freescale MX53LOCO board

[Stefano Babic]

On 04/22/2011 06:36 AM, Jason Hui wrote:
> 
> OK, I will resend the patchset as the following layout:
> 
> MX5: clock: Add clock config interface
> MX5: factor out boot cause funciton to common code
> PMIC: Add dialog pmic support
> MX53: support for freescale MX53LOCO board (merge "Add power init support")
> 
> I will rebase on the u-boot-imx git, do you think is it OK?

Yes, thanks.

>>> +#define CONFIG_SYS_MEMTEST_START       0x70000000
>>> +#define CONFIG_SYS_MEMTEST_END         0x70010000
>>
>> There is still an open question about this range. Can you answer to
>> Wolfgang's question ?
> 
> In fact, I want to give one simple test range when use mtest, I don't know
> what you are worrying about, please tell it clearly?

I think the only issue is if there is some reasons to set the test range
to only 64KB, except the fact this was the value set for the mx51evk. If
you do not see any special reasons, you could increase the
CONFIG_SYS_MEMTEST_END to a larger value.

Best regards,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================