[U-Boot] [PATCH v2 0/17] tegra: Add fdt definitions and USB driver
Simon Glass
sjg at chromium.org
Sat Dec 3 03:11:23 CET 2011
This series brings in the kernel fdt file, adds USB definitions support
to it, and provides a working USB driver for Tegra2 Seaboard.
(I have done this in one series since otherwise most of the fdt additions
will just look like dead code.)
The driver requires CONFIG_OF_CONTROL and a device tree to operate.
Some enhancements to fdtdec are required to make this easier, and these
are included in the series also. I have had to bring in basic GPIO
support due to the request to put the USB VBUS into the fdt.
Since the kernel recently got a very minimal USB binding, I have started
with that and extended it where appropriate.
Changes in v2:
- Use "okay" rather than "ok" in fdt to signify an enabled node
- Add header prototype for fdtdec_next_compatible()
- Change fdtdec_next_alias() to increment 'upto' only on success
- Rename get_prop_len() to get_prop_check_min_len()
- New patch to add gpio_request() to asm-generic header
- Pulled USB fdt definitions from newer for-next instead of master
- Change fdt property usbparmas to usbtiming
- Add details for port USB2
- Use "okay" instead of "ok" for fdt node status
- Remove 0x from fdt aliases
- Tidy code style in USB buffer alignment code
- Display prominent warning when alignment code is triggered
- Rename params to timing
- Store entire fdt config in port list, not just register pointer
- Remove non-fdt operation of USB, since it is not needed
- Decode USB VBUS GPIO from the fdt
- Decode phy type differently (to match new kernel fdt)
- Rename tegra20-usb to tegra20-ehcui (to match new kernel fdt)
- Improve debug() printouts in case of failure to init USB
- Add setting of pinmux for USB VBUS GPIO
- Remove unneeded CONFIG_TEGRA_USBx defines
Simon Glass (17):
fdt: Tidy up a few fdtdec problems
fdt: Add functions to access phandles, arrays and bools
Add gpio_request() to asm-generic header
fdt: Add basic support for decoding GPIO definitions
arm: fdt: Ensure that an embedded fdt is word-aligned
arm: fdt: Add skeleton device tree file from kernel
tegra: fdt: Add Tegra2x device tree file from kernel
tegra: fdt: Add device tree file for Tegra2 Seaboard from kernel
tegra: usb: fdt: Add additional device tree definitions for USB ports
tegra: usb: fdt: Add USB definitions for Tegra2 Seaboard
usb: Add support for data alignment
usb: Add support for txfifo threshold
tegra: usb: Add support for Tegra USB peripheral
tegra: usb: Add USB support to nvidia boards
tegra: usb: Add common USB defines for tegra2 boards
tegra: usb: Enable USB on Seaboard
tegra: fdt: Enable FDT support for Seaboard
README | 9 +
arch/arm/cpu/armv7/tegra2/Makefile | 4 +-
arch/arm/cpu/armv7/tegra2/config.mk | 2 +
arch/arm/cpu/armv7/tegra2/usb.c | 398 +++++++++++++++++++++++++++++
arch/arm/cpu/armv7/u-boot.lds | 5 +
arch/arm/dts/skeleton.dtsi | 13 +
arch/arm/dts/tegra20.dtsi | 238 +++++++++++++++++
arch/arm/include/asm/arch-tegra2/tegra2.h | 2 +
arch/arm/include/asm/arch-tegra2/usb.h | 255 ++++++++++++++++++
board/nvidia/common/board.c | 8 +
board/nvidia/dts/tegra2-seaboard.dts | 48 ++++
drivers/usb/host/Makefile | 1 +
drivers/usb/host/ehci-hcd.c | 36 +++
drivers/usb/host/ehci-tegra.c | 63 +++++
drivers/usb/host/ehci.h | 6 +-
dts/Makefile | 2 +-
include/asm-generic/gpio.h | 10 +
include/configs/seaboard.h | 12 +
include/configs/tegra2-common.h | 14 +
include/fdtdec.h | 113 ++++++++-
lib/fdtdec.c | 182 +++++++++++++-
21 files changed, 1408 insertions(+), 13 deletions(-)
create mode 100644 arch/arm/cpu/armv7/tegra2/usb.c
create mode 100644 arch/arm/dts/skeleton.dtsi
create mode 100644 arch/arm/dts/tegra20.dtsi
create mode 100644 arch/arm/include/asm/arch-tegra2/usb.h
create mode 100644 board/nvidia/dts/tegra2-seaboard.dts
create mode 100644 drivers/usb/host/ehci-tegra.c
--
1.7.3.1
More information about the U-Boot
mailing list