[U-Boot] [PATCH v3 13/15] arm, da850evm: Add an SPL for SPI boot

[Christian Riesch]

Hi Tom,
Thanks for your comments.

On Friday, December 2, 2011, Tom Rini <trini at ti.com> wrote:
> On 12/02/2011 09:12 AM, Christian Riesch wrote:
>
> [snip]
>>  include/configs/da850evm.h            |   87
+++++++++++++++++++++++++++++++++
> [snip]
>> +#define CONFIG_SYS_DA850_DDR2_SDTIMR (0 |    \
>> +     (14 << DV_DDR_SDTMR1_RFC_SHIFT) |       \
>> +     (2 << DV_DDR_SDTMR1_RP_SHIFT) |         \
>> +     (2 << DV_DDR_SDTMR1_RCD_SHIFT) |        \
>> +     (1 << DV_DDR_SDTMR1_WR_SHIFT) |         \
>> +     (5 << DV_DDR_SDTMR1_RAS_SHIFT) |        \
>> +     (8 << DV_DDR_SDTMR1_RC_SHIFT) |         \
>> +     (1 << DV_DDR_SDTMR1_RRD_SHIFT) |        \
>> +     (0 << DV_DDR_SDTMR1_WTR_SHIFT))
>
> '0 | ..' and '0 << ...' don't help readability over just value saying it
> (same with shifting 0).  Also, unless the manual these come from uses
> decimal here, hex is preferred.  Thanks!
>

'0 | ...'.   I agree, I'll remove this.

'0 << ...'
Aaaahhh... Yes, that's pretty useless here, the WTR bits are reserved bits
:-/

Decimal values: I'd like to keep them. This is DDR timing, the numbers mean
number of clock cycles minus one. So actually (1 <<
DV_DDR_SDTMR1_RRD_SHIFT) means that trrd=13.3333... ns (two clock cycles)
at 150 MHz. So I must calculate with these numbers and this is why I prefer
decimal over hex. I am lazy ;-)

Christian


> --
> Tom
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> http://lists.denx.de/mailman/listinfo/u-boot
>