[U-Boot] [ARM]: File type for u-boot elf file

[Tom Rini]

On Mon, Dec 5, 2011 at 2:19 AM, rojan <rojan.joy at bpltelecom.com> wrote:
>  I have OMAP L138 Hawkboard which is loaded with some other program.
> I am new to this hawkboard and tried to boot as per instructions from
> user guide in http://www.hawkboard.org/ , system is not coming to
> hawkboard.org > to access command. It is coming as follows.
>
> Please help me to make it ready.
>
> Switch positions made as follows
>
> Pin1 = ON
> Pin2 = OFF
> Pin3 = OFF
> Pin4 = OFF
>
> Terminal data as follows:
>
> U-Boot 2009.01-dirty (Nov 26 2009 - 02:15:00)
>
> DRAM:  128 MB
> NAND:  NAND device: Manufacturer ID: 0x2c, Chip ID: 0xa1 (Micron NAND
> 128MiB 1,8
> V 8-bit)
> Bad block table found at page 65472, version 0x01
> Bad block table found at page 65408, version 0x01
> nand_read_bbt: Bad block at 0x03500000
> nand_read_bbt: Bad block at 0x049a0000
> 128 MiB
> In:    serial
> Out:   serial
> Err:   serial
> ARM Clock : 300000000 Hz
> DDR Clock : 150000000 Hz
> Ethernet PHY: GENERIC @ 0x07
> Hit any key to stop autoboot:  0

During this countdown you need to 'hit any key' to stop the boot from
happening and give you the U-Boot prompt.

-- 
Tom