[U-Boot] [PATCH 1/2] powerpc/85xx: Add Support for Freescale P1010 Processor

[Kumar Gala]

On Jan 14, 2011, at 10:41 AM, Kumar Gala wrote:

> From: Poonam Aggrwal <poonam.aggrwal at freescale.com>
> 
> Key Features include of the P1010:
> * e500v2 core frequency operation of 500 to 800 MHz
> * Power consumption less than 5.0 W at 800 MHz core speed
> * Dual SATA 3 Gbps controllers with integrated PHY
> * Dual PCI Express controllers
> * Three 10/100/1000 Mbps enhanced triple-speed Ethernet controllers (eTSECs)
> 	* TCP/IP acceleration and classification capabilities
> 	* IEEE 1588 support
> 	* Lossless flow control
> 	* RGMII, SGMII
> * DDR3 with support for a 32-bit data interface (40 bits including ECC),
>  up to 800 MHz data rate 32/16-bit DDR3 memory controller
> * Dedicated security engine featuring trusted boot
> * TDM interface
> * Dual controller area networks (FlexCAN) controller
> * SD/MMC card controller supporting booting from Flash cards
> * USB 2.0 host and device controller with an on-chip, high-speed PHY
> * Integrated Flash controller (IFC)
> * Power Management Controller (PMC)
> * Four-channel, general-purpose DMA controller
> * I2C controller
> * Serial peripheral interface (SPI) controller with master and slave support
> * System timers including a periodic interrupt timer, real-time clock,
>  software watchdog timer, and four general-purpose timers
> * Dual DUARTs
> 
> Signed-off-by: Poonam Aggrwal <poonam.aggrwal at freescale.com>
> Signed-off-by: Dipen Dudhat <dipen.dudhat at freescale.com>
> Signed-off-by: Kumar Gala <galak at kernel.crashing.org>
> ---
> arch/powerpc/cpu/mpc85xx/Makefile    |    1 +
> arch/powerpc/cpu/mpc8xxx/cpu.c       |    2 ++
> arch/powerpc/include/asm/config.h    |    6 ++++--
> arch/powerpc/include/asm/processor.h |    2 ++
> drivers/misc/fsl_law.c               |    1 +
> 5 files changed, 10 insertions(+), 2 deletions(-)

applied to 85xx

- k