[U-Boot] [PATCH 1/2] powerpc/85xx: Add Support for Freescale P1010 Processor

Wolfgang Denk wd at denx.de
Wed Jan 19 09:09:21 CET 2011


Dear Kumar Gala,

In message <1295023271-11897-1-git-send-email-galak at kernel.crashing.org> you wrote:
> From: Poonam Aggrwal <poonam.aggrwal at freescale.com>
> 
> Key Features include of the P1010:
> * e500v2 core frequency operation of 500 to 800 MHz
> * Power consumption less than 5.0 W at 800 MHz core speed
> * Dual SATA 3 Gbps controllers with integrated PHY
> * Dual PCI Express controllers
> * Three 10/100/1000 Mbps enhanced triple-speed Ethernet controllers (eTSECs)
> 	* TCP/IP acceleration and classification capabilities
> 	* IEEE 1588 support
> 	* Lossless flow control
> 	* RGMII, SGMII
> * DDR3 with support for a 32-bit data interface (40 bits including ECC),
>   up to 800 MHz data rate 32/16-bit DDR3 memory controller
> * Dedicated security engine featuring trusted boot
> * TDM interface
> * Dual controller area networks (FlexCAN) controller
> * SD/MMC card controller supporting booting from Flash cards
> * USB 2.0 host and device controller with an on-chip, high-speed PHY
> * Integrated Flash controller (IFC)
> * Power Management Controller (PMC)
> * Four-channel, general-purpose DMA controller
> * I2C controller
> * Serial peripheral interface (SPI) controller with master and slave support
> * System timers including a periodic interrupt timer, real-time clock,
>   software watchdog timer, and four general-purpose timers
> * Dual DUARTs
> 
> Signed-off-by: Poonam Aggrwal <poonam.aggrwal at freescale.com>
> Signed-off-by: Dipen Dudhat <dipen.dudhat at freescale.com>
> Signed-off-by: Kumar Gala <galak at kernel.crashing.org>
...
> --- a/arch/powerpc/include/asm/config.h
> +++ b/arch/powerpc/include/asm/config.h
> @@ -69,14 +69,16 @@
>  
>  /* Enable TSEC2.0 for the platforms that have it if we are using TSEC */
>  #if defined(CONFIG_TSEC_ENET) && \
> -    (defined(CONFIG_P1020) || defined(CONFIG_P1011))
> +    (defined(CONFIG_P1010) || \
> +     defined(CONFIG_P1020) || defined(CONFIG_P1011))

Please keep list sorted.


Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Nobody goes to that restaurant anymore. It's too crowded.


More information about the U-Boot mailing list