[U-Boot] [PATCH V2 3/5] nand spl: add NAND Library to new SPL

[Simon Schwarz]

Dear Andreas,

On 07/26/2011 07:59 AM, Andreas Bießmann wrote:
> Dear Simon,
>
> Am 25.07.2011 um 20:05 schrieb Simon Schwarz:
>
>> Insert some NAND driver sources into NAND SPL library.
>>
>> ---
>> V1 changes:
>> CHG Default to HW ecc in SPL build
>> ADD nand_read_buf16 function, read buffer
>> ADD omap_dev_ready function, indicte if chip is ready
>>
>> V2 changes:
>> DEL GPMC_WAIT0_PIN_ACTIVE define
>> CHG omap_dev_ready() renamed to  omap_spl_dev_ready(), does not use the
>> 	GPMC_WAIT0_PIN_ACTIVE-define anymore
>> CHG ogpmc_read_buf16 renamed omap_spl_read_buf16
>> ADD omap_spl_read_buf, 8x buf read function
>> ADD CONFIG_SPL_POWER_SUPPORT and CONFIG_SPL_NAND_SUPPORT to SPL
>> CHG cosmetic
>> CHG nand_base and nand_bbt aren't needed for SPL anymore
>> CHG omap_nand_switch_ecc is not compiled for SPL
>> ADD entry for CONFIG_SPL_POWER_SUPPORT and CONFIG_SPL_NAND_SUPPORT to README.SPL
>>
>> Transition from V1 to V2 also includes that this patch is now based on
>> 	- the new SPL layout by Aneesh V and Daniel Schwierzeck
>> 	- the OMAP4 SPL patches by Aneesh V
>>
>> This Patch is related to "[U-Boot,4/5] devkit8000 nand_spl: Add SPL NAND support
>> to omap_gpmc driver"
>> (http://article.gmane.org/gmane.comp.boot-loaders.u-boot/102115) in V1
>>
>> Signed-off-by: Simon Schwarz<simonschwarzcor at gmail.com>
>> ---
>> doc/README.SPL               |    2 +
>> drivers/mtd/nand/Makefile    |    6 +++-
>> drivers/mtd/nand/omap_gpmc.c |   69 ++++++++++++++++++++++++++++++++++++++++++
>> spl/Makefile                 |    2 +
>> 4 files changed, 78 insertions(+), 1 deletions(-)
>
> <snip>
>
>> --- a/drivers/mtd/nand/omap_gpmc.c
>> +++ b/drivers/mtd/nand/omap_gpmc.c
>> @@ -61,6 +61,55 @@ static void omap_nand_hwcontrol(struct mtd_info *mtd, int32_t cmd,
>> 		writeb(cmd, this->IO_ADDR_W);
>> }
>
> <snip>
>
>> @@ -224,6 +273,8 @@ static void omap_enable_hwecc(struct mtd_info *mtd, int32_t mode)
>> 	}
>> }
>>
>> +
>
> This single line is unnecessary.
deleted...
>
>> +#ifndef CONFIG_SPL_BUILD
>> /*
>>   * omap_nand_switch_ecc - switch the ECC operation b/w h/w ecc and s/w ecc.
>>   * The default is to come up on s/w ecc
>> @@ -280,6 +331,7 @@ void omap_nand_switch_ecc(int32_t hardware)
>>
>
> regards
>
> Andreas Bießmann

regards
Simon