[U-Boot] [PATCH v2 7/8] arm/km: change default settings for egiga on mgcoge3un

[Prafulla Wadaskar]

> -----Original Message-----
> From: Valentin Longchamp [mailto:valentin.longchamp at keymile.com]
> Sent: Tuesday, May 03, 2011 7:43 PM
> To: u-boot at lists.denx.de
> Cc: Prafulla Wadaskar; holger.brunck at keymile.com; Valentin Longchamp;
> Wolfgang Denk; Detlev Zundel
> Subject: [PATCH v2 7/8] arm/km: change default settings for egiga on
> mgcoge3un
> 
> From: Holger Brunck <holger.brunck at keymile.com>
> 
> The reason we need this is that we have the gig port on mgcoge3un
> connected using a back-to-back pair of PHYs. There are no magnetics and
> because of that the port has to be run with a fixd configuration and
> auto-negotiation must be disabled. In the default mode the egiga driver
> uses autoneg to determine port speed - which defaults to 1G (we need
> 100M full duplex).
> 
> Signed-off-by: Valentin Longchamp <valentin.longchamp at keymile.com>
> Signed-off-by: Holger Brunck <holger.brunck at keymile.com>
> Acked-by: Heiko Schocher <hs at denx.de>
> Acked-by: Prafulla Wadaskar <Prafulla at marvell.com>
> cc: Wolfgang Denk <wd at denx.de>
> cc: Detlev Zundel <dzu at denx.de>
> ---
> Changes for v2:
>    - split up first large patch series to three independent smaller
>      patch series
> 
>  drivers/net/mvgbe.h         |    2 ++
>  include/configs/mgcoge3un.h |   25 +++++++++++++++++++++++++

It will be good if you split this patch, the mvgbe.h change would be generic, independent and can be merged faster.

mgcoge3un.h changes would be part of your new board config.

Regards..
Prafulla ..