[U-Boot] [PATCH v2 7/8] arm/km: change default settings for egiga on mgcoge3un

[Valentin Longchamp]

Prafulla Wadaskar wrote:
> 
>> -----Original Message-----
>> From: Valentin Longchamp [mailto:valentin.longchamp at keymile.com]
>> Sent: Tuesday, May 03, 2011 7:43 PM
>> To: u-boot at lists.denx.de
>> Cc: Prafulla Wadaskar; holger.brunck at keymile.com; Valentin Longchamp;
>> Wolfgang Denk; Detlev Zundel
>> Subject: [PATCH v2 7/8] arm/km: change default settings for egiga on
>> mgcoge3un
>>
>> From: Holger Brunck <holger.brunck at keymile.com>
>>
>> The reason we need this is that we have the gig port on mgcoge3un
>> connected using a back-to-back pair of PHYs. There are no magnetics and
>> because of that the port has to be run with a fixd configuration and
>> auto-negotiation must be disabled. In the default mode the egiga driver
>> uses autoneg to determine port speed - which defaults to 1G (we need
>> 100M full duplex).
>>
>> Signed-off-by: Valentin Longchamp <valentin.longchamp at keymile.com>
>> Signed-off-by: Holger Brunck <holger.brunck at keymile.com>
>> Acked-by: Heiko Schocher <hs at denx.de>
>> Acked-by: Prafulla Wadaskar <Prafulla at marvell.com>
>> cc: Wolfgang Denk <wd at denx.de>
>> cc: Detlev Zundel <dzu at denx.de>
>> ---
>> Changes for v2:
>>    - split up first large patch series to three independent smaller
>>      patch series
>>
>>  drivers/net/mvgbe.h         |    2 ++
>>  include/configs/mgcoge3un.h |   25 +++++++++++++++++++++++++
> 
> It will be good if you split this patch, the mvgbe.h change would be generic, independent and can be merged faster.
> 
> mgcoge3un.h changes would be part of your new board config.
> 

Ok, I agree, I will split them.

Regards

-- 
Valentin Longchamp
Embedded Software Engineer
Hardware and Chip Integration
______________________________________
KEYMILE AG
Schwarzenburgstr. 73
CH-3097 Liebefeld
Phone +41 31 377 1318
Fax   +41 31 377 1212
valentin.longchamp at keymile.com
www.keymile.com
______________________________________
KEYMILE: A Specialist as a Partner