[U-Boot] Memory size detection on P1011

Felix Radensky felix at embedded-sol.com
Fri May 6 08:11:54 CEST 2011


Hi York,

On 05/05/2011 10:43 PM, Wolfgang Denk wrote:
> Dear Felix Radensky,
>
> In message<4DC2F72F.2050009 at embedded-sol.com>  you wrote:
>> The closest example of using get_ram_size() I've found is
>> for MPC8548 TQM boards. But all these boards have 4-bank
>> memory devices, so I'm sure my case was tested. Don't you
>> think there can be a problem with reprogramming bank number
>> in this particular DDR controller ?
> I haven't done this myself yet on this hardware, but I would be very
> surprised if you could not reprogram the controller.
>
>

Can you please clarify this for me. If I understand you correctly,
the number of banks cannot be changed after DDR controller was
initialized. Is my understanding correct ?

Thanks a lot.

Felix.



More information about the U-Boot mailing list