[U-Boot] [PATCH v2 1/3] MX5: Make the weim structure complete

[Stefano Babic]

On 05/17/2011 07:06 AM, Jason Liu wrote:
> Hi, Fabio,
> 
> 2011/5/17 Fabio Estevam <fabio.estevam at freescale.com>:
>> Make the weim register set complete for MX51/MX53.
>>
>> While at it also add the weim chip select 1 address definition.
>>
> 
> From the code, you just add the cs for mx53 not for mx51, so,
> Had better specify you add the cs1 address definition for mx53,
> otherwise, it will make confusion.

Sure ? The structure is not protected by any CONFIG_MX5x switch, and at
least one mx51 board uses it. The registers have the same layout for
both processor. Why do you think is only for MX53 ?

Regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================