[U-Boot] [PATCH 1/5] mx53loco: Configure the pins as GPIOs prior to using gpio_get_value

[Fabio Estevam]

Configure the pins as GPIO prior to using gpio_get_value.

Cc: Jason Liu <r64343 at freescale.com>
Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
---
 board/freescale/mx53loco/mx53loco.c |    3 +++
 1 files changed, 3 insertions(+), 0 deletions(-)

diff --git a/board/freescale/mx53loco/mx53loco.c b/board/freescale/mx53loco/mx53loco.c
index b4c7f33..5e5c38f 100644
--- a/board/freescale/mx53loco/mx53loco.c
+++ b/board/freescale/mx53loco/mx53loco.c
@@ -139,6 +139,9 @@ struct fsl_esdhc_cfg esdhc_cfg[2] = {
 int board_mmc_getcd(u8 *cd, struct mmc *mmc)
 {
 	struct fsl_esdhc_cfg *cfg = (struct fsl_esdhc_cfg *)mmc->priv;
+
+	mxc_request_iomux(MX53_PIN_EIM_DA11, IOMUX_CONFIG_ALT1);
+	mxc_request_iomux(MX53_PIN_EIM_DA13, IOMUX_CONFIG_ALT1);
 
 	if (cfg->esdhc_base == MMC_SDHC1_BASE_ADDR)
 		*cd = gpio_get_value(77); /*GPIO3_13*/
-- 
1.7.1