[U-Boot] [PATCH v2 2/2] omap4_panda: Build in cmd_gpio support on panda

Igor Grinberg grinberg at compulab.co.il
Sun Oct 9 12:47:47 CEST 2011


Hi Joe,

On 10/06/11 23:50, Joe Hershberger wrote:
> Enable the gpio command
> 
> Signed-off-by: Joe Hershberger <joe.hershberger at ni.com>
> Cc: Joe Hershberger <joe.hershberger at gmail.com>
> Cc: Sandeep Paulraj <s-paulraj at ti.com>
> ---
> Changes for v2:
>   - Correct a bad merge... sorry.
> 
>  board/ti/panda/panda_mux_data.h |    2 +-
>  include/configs/omap4_panda.h   |    3 +++
>  2 files changed, 4 insertions(+), 1 deletions(-)
> 
> diff --git a/board/ti/panda/panda_mux_data.h b/board/ti/panda/panda_mux_data.h
> index 63448b6..c692c7b 100644
> --- a/board/ti/panda/panda_mux_data.h
> +++ b/board/ti/panda/panda_mux_data.h
> @@ -212,7 +212,7 @@ const struct pad_conf_entry wkup_padconf_array_non_essential[] = {
>  	{PAD0_FREF_SLICER_IN, (M0)},		/* fref_slicer_in */
>  	{PAD1_FREF_CLK_IOREQ, (M0)},		/* fref_clk_ioreq */
>  	{PAD0_FREF_CLK0_OUT, (M2)},		/* sys_drm_msecure */
> -	{PAD1_FREF_CLK3_REQ, M7},					/* safe mode */
> +	{PAD1_FREF_CLK3_REQ, M7},		/* safe mode */
>  	{PAD0_FREF_CLK3_OUT, (M0)},		/* fref_clk3_out */
>  	{PAD1_FREF_CLK4_REQ, (PTU | M3)},	/* led status_1 */
>  	{PAD0_FREF_CLK4_OUT, (PTU | M3)},	/* led status_2 */
> diff --git a/include/configs/omap4_panda.h b/include/configs/omap4_panda.h
> index 67da70e..b88e5ad 100644
> --- a/include/configs/omap4_panda.h
> +++ b/include/configs/omap4_panda.h
> @@ -35,6 +35,9 @@
>  
>  #include <configs/omap4_common.h>
>  
> +/* GPIO */
> +#define CONFIG_CMD_GPIO 1

Boolean defines should not have a value.


-- 
Regards,
Igor.


More information about the U-Boot mailing list