[U-Boot] [PATCH 1/4] davinci: emac: add new features to autonegotiate for EMAC

[Hadli, Manjunath]

Laurence,
On Sat, Oct 01, 2011 at 02:37:34, Laurence Withers wrote:
> On Fri, Sep 30, 2011 at 05:27:09PM +0530, nagabhushana.netagunte at ti.com wrote:
> > From: Nagabhushana Netagunte <nagabhushana.netagunte at ti.com>
> > 
> > add more features like DUPLEX, 100MB link speed etc to auto negotiate 
> > in EMAC driver. EMAC controller autonegotiates for these features with 
> > PHYs which are on the board.
> > 
> > Signed-off-by: Sudhakar Rajashekhara <sudhakar.raj at ti.com>
> > Signed-off-by: Nagabhushana Netagunte <nagabhushana.netagunte at ti.com>
> 
> I tried this on a board I am developing with an OMAP-L138. I have a managed switch and tried a few different port settings (auto negotiate enabled and disabled etc.) with no problems at all. If you like, please feel free to add:
> 
> Tested-by: Laurence Withers <lwithers at guralp.com>
> 
Thank you!
-Manju

> Bye for now,
> -- 
> Laurence Withers, <lwithers at guralp.com>                http://www.guralp.com/
> Direct tel:+447753988197 or tel:+443333408643               Software Engineer
> General support queries: <support at guralp.com>         CMG-DCM CMG-EAM CMG-NAM
>