[U-Boot] No prompt on mx25pdk boot

[Fabio Estevam]

Hi Hugo,

On Thu, Oct 20, 2011 at 2:04 PM, Hugo Holgersson
<hugoh at student.chalmers.se> wrote:
> Dear readers,
>
> I have problems running U-Boot on my i.MX 25 PDK board.
>
> I have tried two methods:
>
> (A)
> git clone git://www.denx.de/git/u-boot-imx.git master
> nano board/freescale/mx25pdk/imximage.cfg  # change to BOOT_FROM nand
> make CROSS_COMPILE=arm-none-linux-gnueabi- mx25pdk_config
> make CROSS_COMPILE=arm-none-linux-gnueabi- u-boot.imx
>
> The u-boot.imx is flashed using FreeScale AVK to address 0x400 in NAND. This image does not work (no UART output).

I have only tested booting MX25PDK from the SD card. Does this method
work for you?

Regards,

Fabio Estevam