[U-Boot] Syncing custodian tree (the new way) - What am I doing wrong?

[Graeme Russ]

Hi Albert,

On 25/10/11 22:05, Albert ARIBAUD wrote:
> Le 25/10/2011 09:53, Wolfgang Denk a écrit :
>> Dear Graeme Russ,
>>
>> In message<4EA66869.7000106 at gmail.com>  you wrote:
>>>
>>> I'm trying to figure out what I'm doing wrong trying to sync my local x86
>>> repo as per the 'new' instructions on the wiki. This is what I get:
>>
>> I did not write (and actually not even read yet) these new
>> instructions, so I cannot comment on this.
>>
>>> graeme at helios:~/Source/U-Boot/x86$ git rebase ${upstream}/master
>>> fatal: Needed a single revision
>>> invalid upstream u-boot/master
>>
>> Albert?
> 
> (answering from my non-U-boot address)
> 
> I did write the changes, and I think I did post an announcement on the
> U-Boot list about it.
> 
> Re: Greame's problem:
> 
> I should have made it clear that '${upstream}' is just a way to represent
> the upstream tree, either u-boot or u-boot-arm. The actual command for x86
> should thus be
> 
>     git rebase u-boot/master

I was already clear on that - I had set upstream=u-boot - Note the error
message:

fatal: Needed a single revision
invalid upstream u-boot/master
                 ^^^^^^
I think the problem is at:

git fetch git://git.denx.de/${upstream}.git

Where are we actually pulling the upstream tree into?

No my repo is at ~/Source/U-Boot/x86/ and I have uboot and master branches
there (as per previous wiki instructions) so I tried:

git checkout uboot
git fetch git://git.denx.de/${upstream}.git
git checkout master
git rebase ${upstream}/master

But that is not right - I would normally rebase to uboot

I think there is a missing link here somewhere

> 
> (or whatever name you gave to the upstream tree remote)
> 
> Alternatively, one could do
> 
>     setenv upstream u-boot
> or
>     set upstream=u-boot
> 
> depending on the shell used.
> 
> I'll amend the Wiki pages to make that clear.
> 

Regards,

Graeme