[U-Boot] [PATCH v5 2/3] Armada100: Enable Ethernet support for GplugD

[Prafulla Wadaskar]

> -----Original Message-----
> From: Ajay Bhargav [mailto:ajay.bhargav at einfochips.com]
> Sent: Thursday, September 08, 2011 10:09 AM
> To: Wolfgang Denk
> Cc: Prafulla Wadaskar; u-boot at lists.denx.de
> Subject: Re: [U-Boot] [PATCH v5 2/3] Armada100: Enable Ethernet support
> for GplugD
> 
> 
> ----- "Wolfgang Denk" <wd at denx.de> wrote:
> 
> > Dear Ajay Bhargav,
> >
> > In message
> > <1314940721-1867-2-git-send-email-ajay.bhargav at einfochips.com> you
> > wrote:
> > > This patch enables ethernet support for Marvell GplugD board.
> > Network
> > > related commands works.
> > ...
> >
> > > +#define CONFIG_BOOTP_SERVERIP
> >
> > Please remove this line.
> >
> > Best regards,
> >
> > Wolfgang Denk
> >
> > --
> > DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
> > HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
> > Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
> > Roses are red
> > Violets are blue
> > Some poems rhyme
> >
> 
> Dear Wolfgang,
> 
> I asked Prafulla if he can remove that unwanted line. If it is not
> possible then I can resubmit the patch with that change.

Hi Ajay,
Ideally you should do it :-) there are also two more suggestions.
Please do the needful, test it and post v6 patch series.

Hi Wolfgang,
I would like to pull this patch series into u-boot-marvell.git for Ben. I hope this will be okay with you.

Regards..
Prafulla . .