[U-Boot] [PATCH 07/15] iMX28: Add SPI driver

[Mike Frysinger]

On Monday, September 12, 2011 00:06:41 Marek Vasut wrote:
> +struct spi_slave *spi_setup_slave(unsigned int bus, unsigned int cs,
> +				  unsigned int max_hz, unsigned int mode)
> +{
> +
> +	mx28_reset_block(&ssp_regs->hw_ssp_ctrl0_reg);
> +
> +	writel(SSP_CTRL0_BUS_WIDTH_ONE_BIT, &ssp_regs->hw_ssp_ctrl0);
> +
> +	reg = SSP_CTRL1_SSP_MODE_SPI | SSP_CTRL1_WORD_LENGTH_EIGHT_BITS;
> +	reg |= (mode & SPI_CPOL) ? SSP_CTRL1_POLARITY : 0;
> +	reg |= (mode & SPI_CPHA) ? SSP_CTRL1_PHASE : 0;
> +	writel(reg, &ssp_regs->hw_ssp_ctrl1);
> +
> +	writel(0, &ssp_regs->hw_ssp_cmd0);
> +
> +	mx28_set_ssp_busclock(bus, max_hz / 1000);

these steps should be done in the claim_bus func

> +void mxs_spi_start_xfer(struct spi_slave *slave)
> +void mxs_spi_end_xfer(struct spi_slave *slave)

both should be static
-mike
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 836 bytes
Desc: This is a digitally signed message part.
Url : http://lists.denx.de/pipermail/u-boot/attachments/20110912/9b6bf187/attachment.pgp