[U-Boot] [PATCH 2/2] EfikaSB: Add preliminary EfikaSB support

Stefano Babic sbabic at denx.de
Thu Sep 22 16:00:38 CEST 2011


On 09/22/2011 02:29 PM, Marek Vasut wrote:
>> This seems not necessary because CONFIG_MACH_EFIKA* is set at the build
>> time with the option in boards.cfg. With a correct boards.cfg, we cannot
>> get this error.
> 
> Well once someone adds another efika, he can forget about it. And there's mx53 
> efika in the works.

Then there will be a review for the new code. At the moment, this part
behaves as dead code.

Do you mean the same board files will be used ? I am not aware about a
board having two different SOCs. Probably (I say probably, we will see
whan the patches for a new board will be sent...) we will have a
different structure, as the MX53 have different setup as the MX51. In
the same way we have now a mx51evk and mx53evk.

>>>
>>> +#ifndef	CONFIG_MACH_EFIKASB
>>
>> It is better to have the check consistent in the file. You mix #ifdef
>> CONFIG_MACH_EFIKAMX  with #ifndef CONFIG_MACH_EFIKASB, that is the same.
> 
> It expresses the intention much better IMO. And see above -- mx53 efika in the 
> works.

Personally I find confusing if sometimes an #ifdef is used and the next
time #ifndef with the opposite CONFIG is taken, and both part of code
are compiled at the same time.

>> At the moment, the #ifdef seems redundant. You hard-code the efikasb
>> revision to zero, and then get_efika_rev() is always smaller as
>> EFIKAMX_BOARD_REV_12. What about to introduce a macro such as board_is()
>> to increase readability ?
> 
> Yes it would, but it'd also increase code size.

I let you decide.

>>> +#else
>>> +	gd->bd->bi_arch_number = MACH_TYPE_MX51_EFIKASB;
>>> +#endif
>>>
>>>  	gd->bd->bi_boot_params = PHYS_SDRAM_1 + 0x100;
>>
>> Can we use the new rule to set up the MACH-ID ? You can move the #ifdef
>> inside config.h and let common code to set it.
> 
> Can we do that in a subsequent patch ?

Surely, you can add a patch to this patchset.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================


More information about the U-Boot mailing list