[U-Boot] [PATCH 1/4] davinci: emac: add new features to autonegotiate for EMAC

Laurence Withers lwithers at guralp.com
Fri Sep 30 23:07:34 CEST 2011


On Fri, Sep 30, 2011 at 05:27:09PM +0530, nagabhushana.netagunte at ti.com wrote:
> From: Nagabhushana Netagunte <nagabhushana.netagunte at ti.com>
> 
> add more features like DUPLEX, 100MB link speed etc to auto negotiate
> in EMAC driver. EMAC controller autonegotiates for these features with
> PHYs which are on the board.
> 
> Signed-off-by: Sudhakar Rajashekhara <sudhakar.raj at ti.com>
> Signed-off-by: Nagabhushana Netagunte <nagabhushana.netagunte at ti.com>

I tried this on a board I am developing with an OMAP-L138. I have a managed
switch and tried a few different port settings (auto negotiate enabled and
disabled etc.) with no problems at all. If you like, please feel free to add:

Tested-by: Laurence Withers <lwithers at guralp.com>

Bye for now,
-- 
Laurence Withers, <lwithers at guralp.com>                http://www.guralp.com/
Direct tel:+447753988197 or tel:+443333408643               Software Engineer
General support queries: <support at guralp.com>         CMG-DCM CMG-EAM CMG-NAM


More information about the U-Boot mailing list