[U-Boot] [PATCH v4 19/23] tegra: Add EMC settings for Seaboard

[Stephen Warren]

On 04/09/2012 03:40 PM, Simon Glass wrote:
> +Olof
> 
> Hi Stephen,
> 
> On Mon, Apr 9, 2012 at 2:27 PM, Stephen Warren <swarren at wwwdotorg.org> wrote:
>> On 04/05/2012 03:55 PM, Simon Glass wrote:
>>> From: Jimmy Zhang <jimmzhang at nvidia.com>
>>>
>>> Set Seaboard to optimal memory settings based on the SOC in use (T20 or T25).
>>>
>>> Signed-off-by: Simon Glass <sjg at chromium.org>
>>> ---
>>> Changes in v2:
>>> - Move EMC tables to device tree
>>> - Removed check for nominal voltage (not needed as it is done just before)
>>>
>>> Changes in v3:
>>> - Add better error reporting when EMC setup fails
>>>
>>> Changes in v4:
>>> - Remove support for T20 memory timings
>>
>>> diff --git a/board/nvidia/common/emc.c b/board/nvidia/common/emc.c
>>
>>> +/* This rate is hard-coded for now, until fdt provides them */
>>> +#define EMC_SDRAM_RATE_T25   (380000 * 2 * 1000)
>>> +
>>> +int board_emc_init(void)
>>> +{
>>> +     unsigned rate;
>>> +
>>> +     switch (tegra_get_chip_type()) {
>>> +     default:
>>> +     case TEGRA_SOC_T20:
>>> +             debug("%s: EMC timings not supported for T20 Seaboard\n",
>>> +                   __func__);
>>
>> This isn't Seaboard-specific code, so the string shouldn't say
>> "Seaboard" there.
>>
>> Why not support Tegra20? Many/all of the other Tegra boards U-Boot
>> supports are Tegra20 not Tegra25.
>>
>> Presumably this code doesn't blow up if the EMC tables aren't in the
>> .dts file; the code should use the tables if they're present, otherwise
>> be a no-op.
> 
> I don't mind, we can either go with v3 (with T20) or v4 (without).
> Both sets of patches are on the list and the removable of T20 support
> is the only change in v4. Please can you discuss this with Olof?

IIRC, Olof objected to the incorrect Seaboard .dts file (which contained
two unrelated sets of EMC tables for different board variants), not the
ability for the EMC driver itself to function on either Tegra20 or Tegra25.