[U-Boot] [PATCH 2/8] i.MX: Add target flashable to offset 0

[Timo Ketola]

On 12.04.2012 14:11, Stefano Babic wrote:
> On 12/04/2012 11:33, Timo Ketola wrote:
>> +$(obj)u-boot-nand.imx: $(obj)u-boot.imx
>> +		dd if=$<  of=$@ seek=2
>> +
>
> I wonder why we need this in u-boot code and to set this rule in the
> main Makefile. You can always do this after generating u-boot.

Older U-Boot (from FreeScale) made an .imx image with 1KB padding which I could 
flash directly into the NAND at offset 0. Now I had to do manually that 
dd-magic (before I put it in Makefile) because openocd doesn't allow to flash 
at offset 0x400 (it demands write-page alignment).

> The rules here are to generate the u-boot.imx. Then the same image can
> be stored at different addresses. Depending on the i.MX SOC, ofssets can
> be different (MX5 / MX6 have different offsets for NOR / NAND / oneNAND).

I prefer a build system which generates an image ready for flashing but perhaps 
I have to do that outside of U-Boot, somehow.

--

Timo