[U-Boot] [UPDATED] Pull request: u-boot-arm/master

[Wolfgang Denk]

Dear Albert ARIBAUD,

In message <4F8C7E98.5040701 at aribaud.net> you wrote:
> Hi Wolfgang,
> 
> The following changes since commit 3f0675d1a532dbf1fd906103e4b61a6fb842c257:
> 
>    Merge branch 'marek.vasut at gmail.com' of 
> git://git.denx.de/u-boot-staging (2012-04-09 21:34:27 +0200)
> 
> are available in the git repository at:
> 
>    git://git.denx.de/u-boot-arm master
> 
> Anatolij Gustschin (1):
>        ARM1136: add cache flush and invalidate operations
> 
> Bernhard Walle (2):
>        tricorder: Add UBIFS
>        tricorder: Load kernel from ubifs
> 
> Eric Nelson (3):
>        i.MX6: define CACHELINE_SIZE
>        i.MX6: implement enable_caches()
>        i.MX6: mx6qsabrelite: add cache commands if cache is enabled
> 
> Fabio Estevam (4):
>        mx28: Split the README into a common part and a m28 specific part
>        mx28evk: Add a README file
>        mx6qsabrelite: Add boot switch setting information into the README
>        mx6qsabrelite: Fix the serial console port
> 
> Igor Grinberg (1):
>        cm-t35: fix Ethernet reset timing
> 
> Joel Fernandes (1):
>        BeagleBoard: Remove userbutton command and use gpio command instead
> 
> Marek Vasut (6):
>        i.MX28: Fix initial stack pointer position
>        i.MX28: Allow coexistence of PIO and DMA mode for SD/MMC
>        DMA: Split the APBH DMA init into block and channel init
>        M28: Pull out CONFIG_APBH_DMA so it's always enabled
>        ARM926EJS: Make asm routines volatile in cache ops
>        ARM926EJS: Fix cache.c to comply with checkpatch.pl
> 
> Stefano Babic (7):
>        ARM: 926ejs: use debug() for misaligned addresses
>        mx35: flea3: fix when cache functions are linked
>        mx35: mx35pdk: fix when cache functions are linked
>        MX31: mx31pdk: drop enable_caches from board file
>        ARM: add u-boot.imx as target for i.MX SOCs
>        ARM1136: MX35: Make asm routines volatile in cache ops
>        MX35: mx35pdk: wrong board revision
> 
> Tom Rini (2):
>        OMAP: Move omap1510inn to Unmaintained / Orphaned
>        hawkboard: Add CONFIG_SPL_LIBGENERIC_SUPPORT
> 
> Troy Kisky (1):
>        MX53: DDR: Fix ZQHWCTRL field TZQ_CS
> 
> Vikram Narayanan (4):
>        imx: Remove unneeded/repititive definitions from imx headers
>        imx: Add GPIO_TO_PORT macro in the mxc_gpio driver
>        imx: Use GPIO_TO_PORT macro in the gpio driver instead of (gpio >> 5)
>        imx: Return gpio_set_value in gpio_direction_output
> 
>   MAINTAINERS                                |    7 +-
>   arch/arm/cpu/arm1136/cpu.c                 |  103 ++++++++++++-
>   arch/arm/cpu/arm926ejs/cache.c             |   19 +--
>   arch/arm/cpu/arm926ejs/mx28/mx28.c         |    6 +
>   arch/arm/cpu/armv7/config.mk               |    3 +
>   arch/arm/cpu/armv7/mx6/soc.c               |    8 +
>   arch/arm/include/asm/arch-mx28/dma.h       |    4 +-
>   arch/arm/include/asm/arch-mx35/mx35_pins.h |    2 -
>   arch/arm/include/asm/arch-mx5/mx5x_pins.h  |    2 -
>   arch/arm/include/asm/arch-mx6/imx-regs.h   |    4 +-
>   board/cm_t35/cm_t35.c                      |   11 +-
>   board/freescale/mx31pdk/mx31pdk.c          |    8 -
>   board/freescale/mx35pdk/mx35pdk.c          |   11 --
>   board/freescale/mx53ard/imximage_dd3.cfg   |    2 +-
>   board/freescale/mx53evk/imximage.cfg       |    2 +-
>   board/freescale/mx53loco/imximage.cfg      |    2 +-
>   board/freescale/mx53smd/imximage.cfg       |    2 +-
>   board/ti/beagle/beagle.c                   |   55 -------
>   doc/README.m28                             |  219 
> +--------------------------
>   doc/README.mx28_common                     |  226 
> ++++++++++++++++++++++++++++
>   doc/README.mx28evk                         |   29 ++++
>   doc/README.mx6qsabrelite                   |    3 +-
>   drivers/dma/apbh_dma.c                     |   38 ++---
>   drivers/gpio/mxc_gpio.c                    |   12 +-
>   drivers/mmc/mxsmmc.c                       |   53 +++++++-
>   drivers/mtd/nand/mxs_nand.c                |   11 +-
>   include/configs/flea3.h                    |    2 +
>   include/configs/hawkboard.h                |    1 +
>   include/configs/m28evk.h                   |    8 +-
>   include/configs/mx28evk.h                  |    2 +-
>   include/configs/mx35pdk.h                  |    3 +-
>   include/configs/mx6qarm2.h                 |    2 +
>   include/configs/mx6qsabrelite.h            |    8 +-
>   include/configs/omap3_beagle.h             |   11 +-
>   include/configs/tricorder.h                |   15 ++-
>   35 files changed, 530 insertions(+), 364 deletions(-)
>   create mode 100644 doc/README.mx28_common
>   create mode 100644 doc/README.mx28evk

Applied, thanks.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Yes, it's a technical challenge, and  you  have  to  kind  of  admire
people  who go to the lengths of actually implementing it, but at the
same time you wonder about their IQ...
         --  Linus Torvalds in <5phda5$ml6$1 at palladium.transmeta.com>