[U-Boot] Porting u-boot for MPC8280 based board.

Wolfgang Denk wd at denx.de
Thu Apr 26 14:33:33 CEST 2012


Dear Thirumalesha N,

In message <CAO1Rv-a_hPKfmm2ix_Gc0BgokiQk=qMOnUK4NOmuVxkQWXsn=g at mail.gmail.com> you wrote:
> 
> > >  I have BDI 2000 tool, but its not connecting to board.
> >
> > This is a problem that should be fixable.  Keep in mind that the
> > MPC82xx can come up in different modes, depending on if there is a
> > valid HRCW in flash or not.  This can change the start address, too.
> > Try both high and low boot configurations.
> 
>         For reset circuitry HRCW is there. In hardware also its considered.
> if i Want to try for high boot have to change TEXT_BASE address?

In the first place, you must get the BDI working.  To do so, you have
to tweak the BDI config file.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
It is better to marry than to burn.
                                - Bible ``I Corinthians'' ch. 7, v. 9


More information about the U-Boot mailing list