[U-Boot] [PATCH v3 4/4] sandbox: Add basic test for command execution

[Wolfgang Denk]

Dear Simon Glass,

In message <1333179058-19598-4-git-send-email-sjg at chromium.org> you wrote:
> Since run_command() and run_command_list() are important and a little
> confusing, add some basic tests to check that the behaviour is correct.
> 
> Note: I am not sure that this should be committed, nor where it should go
> in the source tree. Comments welcome.
> 
> To run the unit tests use the ut_cmd command available in sandbox:
> 
> make sandbox_config
> make
> ./u-boot -c ut_cmd
> 
> (To test both hush and built-in parsers, you need to manually change
> CONFIG_SYS_HUSH_PARSER in include/configs/sandbox.h and build/run again)
> 
> Signed-off-by: Simon Glass <sjg at chromium.org>
> ---
> Changes in v3:
> - Add some unit tests for run_command() and run_command_list()
> 
>  Makefile          |    1 +
>  test/Makefile     |   45 ++++++++++++++++++++++++++++
>  test/command_ut.c |   85 +++++++++++++++++++++++++++++++++++++++++++++++++++++
>  3 files changed, 131 insertions(+), 0 deletions(-)
>  create mode 100644 test/Makefile
>  create mode 100644 test/command_ut.c

Applied, thanks.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
It usually takes more than three weeks to prepare  a  good  impromptu
speech.                                                  - Mark Twain