[U-Boot] [PATCH] km/arm: set SPI NOR Flash default parameters

[Prafulla Wadaskar]

> -----Original Message-----
> From: Valentin Longchamp [mailto:valentin.longchamp at keymile.com]
> Sent: 15 August 2012 20:46
> To: Prafulla Wadaskar
> Cc: u-boot at lists.denx.de; Holger Brunck
> Subject: Re: [PATCH] km/arm: set SPI NOR Flash default parameters
> 
> Hi Prafulla,
> 
> On 08/14/2012 03:17 PM, Prafulla Wadaskar wrote:
> >
> >
> >> -----Original Message-----
> >> From: Valentin Longchamp [mailto:valentin.longchamp at keymile.com]
> >> Sent: 14 August 2012 17:09
> >> To: Prafulla Wadaskar
> >> Cc: u-boot at lists.denx.de; Valentin Longchamp; Holger Brunck
> >> Subject: [PATCH] km/arm: set SPI NOR Flash default parameters
> >>
> >> These parameters are used by the the sf probe command that are used
> by
> >> our update script and they therefore need to be set for all of our
> >> boards.
> >>
> >> The timing is the same as for the ENV SPI NOR Flash (since it's the
> >> same physical device) and takes the boco2 delay on the bus into
> >
> > What is boco2? Is it typo mistake?
> 
> No typo mistake. It's the name of a chip developped at Keymile that is
> the the
> SPI bus as well.

Thanks for clarification.

Acked-by: Prafulla Wadaskar <Prafulla at marvell.com>
Will pull this patch soon.

Regards...
Prafulla . . .