[U-Boot] [PATCH v2 15/18] ARM: SPL: Convert davinci to CONFIG_SPL_FRAMEWORK

[Christian Riesch]

Hi Tom,

On Mon, Aug 20, 2012 at 6:45 PM, Tom Rini <trini at ti.com> wrote:
> - Convert the non-relocation part of board_init_f to spl_board_init,
>   turn on CONFIG_SPL_BOARD_INIT in the configs.
> - Remove duplicated code.
> - Add spl_boot_device() that returns the statically chosen boot device.

I tested the patchset on the LogicPD AM1808 experimenter's kit:

make da850evm
and flashing to SPI flash with
mono sfh_OMAP-L138.exe -targetType AM1808 -p /dev/ttyUSB0 -flash_noubl
u-boot.ais

The board boots up fine, but after pressing the reset button or
issuing the u-boot "reset" command, it is dead. Only power-cycling
helps. Before enabling the SPL framework in this patch reset works
fine. Any ideas?

Regards, Christian