[U-Boot] [PATCH v2 1/7] mtd/st_smi: Clear error flags while initiating a fresh write

[Stefan Roese]

On 12/06/2012 09:47 AM, Vipin Kumar wrote:
> SMI controller reports an error when the code tries to write on the flash area
> with Write Enable command not issued or the bank has come out of the write mode.
> 
> This error is reported even with a fresh write once the ERF1 or ERF2 is set.
> Clear these flags while initiating a fresh write
> 
> Signed-off-by: Vipin Kumar <vipin.kumar at st.com>

Acked-by: Stefan Roese <sr at denx.de>

Thanks,
Stefan