[U-Boot] [PATCH 01/11] usb: net: asix: Do a fast init if link already established

[Simon Glass]

The Asix driver takes the link down during init() and then brings it back up.
This commit changes this so that if a link has already been established
successfully we simply check that the link is still good.

Also fix up asix_halt() to actually halt RX on the interface. Previously this
was not done, so the device would continue to operate evern when halted,
violating a U-Boot requirement.

This reduces the delay between successive network commands.
Signed-off-by: Simon Glass <sjg at chromium.org>
---
 drivers/usb/eth/asix.c |   40 ++++++++++++++++++++++++++++++++--------
 include/usb_ether.h    |    1 +
 2 files changed, 33 insertions(+), 8 deletions(-)

diff --git a/drivers/usb/eth/asix.c b/drivers/usb/eth/asix.c
index 75ec8f7..a991fea 100644
--- a/drivers/usb/eth/asix.c
+++ b/drivers/usb/eth/asix.c
@@ -84,6 +84,7 @@
 
 #define AX_DEFAULT_RX_CTL	\
 	(AX_RX_CTL_SO | AX_RX_CTL_AB)
+#define AX_DISABLE_RX_CTL	AX_RX_CTL_AB
 
 /* GPIO 2 toggles */
 #define AX_GPIO_GPO2EN		0x10	/* GPIO2 Output enable */
@@ -410,17 +411,16 @@ static int asix_basic_reset(struct ueth_data *dev)
 	return 0;
 }
 
-/*
- * Asix callbacks
- */
-static int asix_init(struct eth_device *eth, bd_t *bd)
+static int full_init(struct eth_device *eth)
 {
-	struct ueth_data	*dev = (struct ueth_data *)eth->priv;
-	int timeout = 0;
-#define TIMEOUT_RESOLUTION 50	/* ms */
-	int link_detected;
+	struct ueth_data *dev = (struct ueth_data *)eth->priv;
 
 	debug("** %s()\n", __func__);
+	if (asix_basic_reset(dev))
+		goto out_err;
+
+	if (asix_write_rx_ctl(dev, AX_DEFAULT_RX_CTL) < 0)
+		goto out_err;
 
 	dev->phy_id = asix_get_phy_addr(dev);
 	if (dev->phy_id < 0)
@@ -446,6 +446,25 @@ static int asix_init(struct eth_device *eth, bd_t *bd)
 		debug("Write IPG,IPG1,IPG2 failed\n");
 		goto out_err;
 	}
+	return 0;
+out_err:
+	return -1;
+}
+
+/*
+ * Asix callbacks
+ */
+static int asix_init(struct eth_device *eth, bd_t *bd)
+{
+	struct ueth_data *dev = (struct ueth_data *)eth->priv;
+	int timeout = 0;
+#define TIMEOUT_RESOLUTION 50	/* ms */
+	int link_detected;
+
+	debug("** %s()\n", __func__);
+
+	if (!dev->has_been_running && full_init(eth))
+		return -1;
 
 	if (asix_write_rx_ctl(dev, AX_DEFAULT_RX_CTL) < 0)
 		goto out_err;
@@ -467,6 +486,7 @@ static int asix_init(struct eth_device *eth, bd_t *bd)
 		printf("unable to connect.\n");
 		goto out_err;
 	}
+	dev->has_been_running = 1;
 
 	return 0;
 out_err:
@@ -571,7 +591,11 @@ static int asix_recv(struct eth_device *eth)
 
 static void asix_halt(struct eth_device *eth)
 {
+	struct ueth_data *dev = (struct ueth_data *)eth->priv;
+
+	/* Disable packet reception */
 	debug("** %s()\n", __func__);
+	(void)asix_write_rx_ctl(dev, AX_DISABLE_RX_CTL);
 }
 
 /*
diff --git a/include/usb_ether.h b/include/usb_ether.h
index 7c7aecb..6145210 100644
--- a/include/usb_ether.h
+++ b/include/usb_ether.h
@@ -49,6 +49,7 @@ struct ueth_data {
 	unsigned char	subclass;		/* as in overview */
 	unsigned char	protocol;		/* .............. */
 	unsigned char	irqinterval;	/* Intervall for IRQ Pipe */
+	char has_been_running;		/* PHY already inited */
 
 	/* driver private */
 	void *dev_priv;
-- 
1.7.7.3