[U-Boot] [PATCH] arm: bugfix: Move vector table before jumping relocated code

[Joel A Fernandes]

On Tue, Dec 25, 2012 at 5:18 PM, Tetsuyuki Kobayashi <koba at kmckk.co.jp> wrote:
> Hello, Joel
>
>
> (2012/12/22 0:17), Joel A Fernandes wrote:
>>
>> Hi Tesuyuki and friends,
>>
>> I had a question with this patch.
>>
>> On Wed, Jun 27, 2012 at 8:27 PM, Tetsuyuki Kobayashi <koba at kmckk.co.jp>
>> wrote:
>>>>>
>>>>> This patch moves vector table before jumping relocated code.
>>>>>
>>>>> Signed-off-by: Tetsuyuki Kobayashi<koba at kmckk.co.jp>
>>>>> ---
>>>>>    arch/arm/cpu/armv7/start.S |   12 ++++++++++++
>>>>>    1 file changed, 12 insertions(+)
>>>>>
>>>>> diff --git a/arch/arm/cpu/armv7/start.S b/arch/arm/cpu/armv7/start.S
>>>>> index 52f7f6e..5098f7b 100644
>>>>> --- a/arch/arm/cpu/armv7/start.S
>>>>> +++ b/arch/arm/cpu/armv7/start.S
>>>>> @@ -277,6 +277,18 @@ jump_2_ram:
>>>>>          mcr     p15, 0, r0, c7, c10, 4  @ DSB
>>>>>          mcr     p15, 0, r0, c7, c5, 4   @ ISB
>>>>>    #endif
>>>>> +/*
>>>>> + * Move vector table
>>>>> + */
>>>>> +#if !defined(CONFIG_TEGRA2)
>>>>> +#if !(defined(CONFIG_OMAP44XX)&&  defined(CONFIG_SPL_BUILD))
>>>>>
>>>>> +       /* Set vector address in CP15 VBAR register */
>>>>> +       ldr     r0, =_start
>>>>> +       add     r0, r0, r9
>>>>> +       mcr     p15, 0, r0, c12, c0, 0  @Set VBAR
>>>>> +#endif
>>
>>
>> Why is c12 (VBAR) setup only for SPL builds? Because main u-boot does
>> relocation too, shouldn't we setup c12 to point to new table addr
>> after relocation?
>
>
> You may mis-understand. ! means NOT.

Yes! Thanks for pointing it out.

Regards,
Joel