[U-Boot] [PATCH v2 17/17] x86: Convert board_init_f_r to a processing loop

[Simon Glass]

Hi Graeme,

On Sun, Jan 8, 2012 at 1:10 AM, Graeme Russ <graeme.russ at gmail.com> wrote:
> On 08/01/12 09:21, Simon Glass wrote:
>> Hi Graeme,
>>
>> On Wed, Jan 4, 2012 at 11:59 AM, Graeme Russ <graeme.russ at gmail.com> wrote:
>>> Create an init function array for board_init_f_r - This finalises the
>>> migration to a purely array based initialisation mechanism
>>>
>>> Also tweak a few comments while we are at it so everything is 'correct'
>>>
>>> Signed-off-by: Graeme Russ <graeme.russ at gmail.com>
>>
>> I have been through this series again and it looks good to me. I don't
>> suppose an Acked-by from me is much use since you are the x86
>> maintainer and I admit to no knowledge of the subject, but let me know
>> if so.
>
> Being a maintainer does not mean I'm infallible ;) - A formal Acked-by
> would be appreciated

OK will do.

>
>> There may be some conflict between your series and the generic board
>> one that I just sent out yesterday but I have not tried it. But now
>> that series is opt-in on a board-by-board basis, we might be ok, and
>> in any case x86 can just opt out until everything works.
>
> Plus this series is not RFC and pending no objections (particularly from
> Wolfgang) I plan to put it in x86/master 'very soon (tm)' and send a pull
> request.

OK

Regards,
Simon

>
> Regards,
>
> Graeme
>