[U-Boot] [PATCH] mx28: fix clearing of IRQs in power init

[Stefano Babic]

On 09/01/2012 21:22, Zach Sadecki wrote:
> There are 2 locations in the power init code for the mx28 where IRQs are not being cleared because incorrect methods to clear those bits were being used.  This was causing my board to get stuck waiting for POWER_CTRL_VDD5V_DROOP_IRQ to clear.  Using the correct method to clear the IRQs fixes it.
> 
> Signed-off-by: Zach Sadecki <zach at itwatchdogs.com>
> Cc: Wolfgang Denk <wd at denx.de>
> Cc: Stefano Babic <sbabic at denx.de>
> ---

Applied to u-boot-imx, thanks.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================